Forum Replies Created
-
Posts
-
The warning lights dont flash as such.. it goes through several different programmes almost like a display then the 3 warning lights blink as in 1 2 3, then the programme display starts again. I am sure she has put it demo
electrofix wrote:you can order miele parts off their website. all parts breakdowns and prices are there
https://www4.miele.de/msd?vg=VG-GB&c…GB&language=en
Bosch can do trade prices so contact them direct
Dave
Looks like Miele have shut this link down.. obviously don’t want other people repairing there stuff! ASWO are saying due to Miele’s new sales policy they aren’t stocking a lot of parts.. I always make point not to reccommend Miele these days
Sorry Dave I have been away.. The dishwasher has filled, washed and heats up then just stops.. If I cancel the programme it drains no problem. No fault code which is strange as this dishwasher does display time.
Could be as I had it out and no noise.. that said when it was pushed back in there was no noise for 20/30 minutes with the compressor running, then off it went. It does appear to be coming from the compressor but it is difficult to pin down. It is about 7 years old and only been noisy for the last year according to the customer.
Thanks for the response Dave.. I will go back and check this but it does switch off quickly, the drain pump definitely runs but can’t be sure of the circumstances pump.
So there is no actual fault codes on this machine?
No this does not show codes just flashes the tap symbol.. I have had the E19 before and you can aways reset after and get it to run. This dishwasher will not re set at all.. I have ordered a control module as I am sure regardless of the fault you can always re set
I have had that problem in the past many times and carry the valves on the van.. I don’t think I have ever had a fault that would not re set though!
If anyone has any info on this I would appreciate it model is SPV40C10GB/32 slimline integratedNo water in the base.. no pump running at all just the “tap” symbol flashing. Disconnected from power supply for 10 minutes as I inspected the base, it will not reset.
Done a few of these recently no heat due to the module.. old module two screw hole in the centre, new one four holes either side so I had to drill two new holes and the drill bits do not like that metal so melted three drill bits 🙁
To be honest I didn’t and I never even checked it.. It is located on the mains module at the rear and I assumed if that had blown it would take everything out! Didn’t realise it was only 8amp given that the microwave is rated at 3.6kw.
Thanks Merv I will go back and check and if your right give myself a slap lol
