Penguin45

Forum Replies Created

Viewing 15 posts - 16,141 through 16,155 (of 19,678 total)
  • Author
    Posts
  • in reply to: Neff fan in oven not working #160767
    Penguin45
    Participant

    Re: Neff fan in oven not working

    http://www.ukwhitegoods.co.uk/modules.p … cts_id=447

    That’s the one you need…..

    Regards,
    Penguin45.

    in reply to: Time and Date #160759
    Penguin45
    Participant

    Re: Time and Date

    Go into Forums, then Profile – tab down, set date/time, Submit.

    Chris.

    in reply to: old zanussi c80412 #160721
    Penguin45
    Participant

    Re: old zanussi c80412

    You’ll need ZN5112 from M/part in that case.

    Chris.

    in reply to: smeg DWI710 #160737
    Penguin45
    Participant

    Re: smeg DWI710

    Sorry, that should have read “led 5 lit and steady”…… That would be the right hand one…..

    Chris.

    in reply to: smeg DWI710 #160735
    Penguin45
    Participant

    Re: smeg DWI710

    If LED 1 is lit and steady as well, it’s E3, no heat.

    Chris.

    in reply to: Penguin or Parrot #160677
    Penguin45
    Participant

    Re: Penguin or Parrot

    He’s out there – somewhere……
    Chris.

    in reply to: Hotpoint Ultima Tumble Dryer (TDC6R?) leak #160716
    Penguin45
    Participant

    Re: Hotpoint Ultima Tumble Dryer (TDC6R?) leak

    Check the rubber cap at the lower rear of the machine. Plenty of dribbles from that.

    Penguin45.

    in reply to: F&P Smartdrive GW508 – Pump always on & won’t fill w #160660
    Penguin45
    Participant

    Re: F&P Smartdrive GW508 – Pump always on & won’t fi

    13 is that the display board has detected the pump running continuously. It’s switched by the motor control board. Be advised that there is a permanent live feed to the pump as long as the machine is plugged in, so be careful when circuit testing.

    Regards,
    Penguin45.

    in reply to: Bosch WVF 2402GB not heating/ drying #160653
    Penguin45
    Participant

    Re: Bosch WVF 2402GB not heating/ drying

    Answers……..
    1) Drain hose works – also hand on door glass after about 15 mins.
    2) Rinses should be cold water only – if they’re warm at the end, the hoses are reversed.
    3) If poking about in the top, you may have reset the safety stat on the dryer box, but more likely that
    4) Clearing the filter is allowing the dryer condenser to operate correctly. There is a constant trickle of cold water running into the machine during the drying cycle, also the steam is condensing off. It all collects in the sump, and the filter must be clear to allow the pump to work efficiently.

    Regards,
    Penguin45.

    in reply to: Urgent message for Penguin45 #160612
    Penguin45
    Participant

    Re: Urgent message for Penguin45

    Wot? Wot…….? Getting kids back from Cubs at that time. No, not interspecies confusion, Cub Scouts……….

    Chris.

    in reply to: Tricity Bendix DH090 dishwasher – not letting water in #160633
    Penguin45
    Participant

    Re: Tricity Bendix DH090 dishwasher – not letting water in

    No, no, no – this is a “blue tubes” machine. If you’re not in and out in 20 minutes, you’re doing something very wrong.

    http://www.ukwhitegoods.co.uk/modules.p … ge&pid=104

    Chris.

    in reply to: Bosch WFB1605 Parts question #160597
    Penguin45
    Participant

    Re: Bosch WFB1605 Parts question

    :wave: 😀

    in reply to: Smartdrive 085 won’t fill #160506
    Penguin45
    Participant

    Re: Smartdrive 085 won’t fill

    Motor controller fault, almost dead cert. P/no 428204BP. Do the obvious – check connectors to board etc (with the power off), but expect the worst. I gather that reconditioned boards can be found at reasonable prices.

    Regards,
    Penguin45.

    in reply to: Bosch WFB1605 Parts question #160595
    Penguin45
    Participant

    Re: Bosch WFB1605 Parts question

    Hinge – p/no 153150 (This is cast alloy, not plastic)
    Door inner panel – p/no 353229
    Door outer panel – p/no 434009

    Take your pick, email to spares@ukwhitegoods.co.uk for prices and ordering.

    Regards,
    Penguin45.

    in reply to: servis no drum turn #160531
    Penguin45
    Participant

    Re: servis no drum turn

    Bill wrote:QER are not very good at repairing Servis modules!

    But EMW are……….

    Chris.

Viewing 15 posts - 16,141 through 16,155 (of 19,678 total)