Forum Replies Created
-
Posts
-
Re: SGS6312GB
Probably the PTC actuator on the box failed. P/no 166635, order from http://www.bshappliancecare.com – cheap.
You need to look from the inside of the door to be sure. Mind the edges, they’re lethal.
Regards,
Penguin45.Re: Bosch SGS5312GB/12 doesn’t stop or drain
Check this Andy – may explain the heat side of things.
http://www.ukwhitegoods.co.uk/modules.p … w=previous
As for the water left in the bottom, it is possible that the sink coupling is restricted, or that the fill/drain matrix under the left hand side panel is obstructed in some way.
Also possible that the computer has lost it’s marbles………
Regards,
Penguin45.Re: Zanussi ZDT 6894 no fill
Always…….. Excess froth and foam, poor heating as a consequence, salt in the wash – it just goes on and on.
Chris.
Re: Zanussi ZDT 6894 no fill
1524624-20/0 – about £47 list. Last one I did didn’t have instructions, but it was pretty obvious once you started offering things up.
Cheers,
Chris.Re: Content Of This Forum
No. Re-organisation……….
http://www.ukwhitegoods.co.uk/modules.p … pic&t=5898
Chris.
Re: Advertising Scam
That’s very restrained of you, Martin. Personally I tend to invoke sex and travel….. 😀
Chris.
Re: SMEG DWF66 Reset Procedure?
Ok, I think I’ve got it – once the test sequence has started, you’ve got to run all of it. However, it stops at C4 and C9 – you have to press “start” for it to continue. When it finishes, open the door, switch off, wait and switch on again. Normal programming should return.
And have a little word with the small person in the house about pushing buttons…..
Regards,
Penguin45.Re: Mistral FF72 fault?
Hi Tony, can’t advise you directly, but there are 17 “Mistral” threads if you check the search facility; most relate to temepature problems. Failing that, hang fire ’til morning when the rest of the lads are back on their feet.
Regards,
Penguin45.Re: SMEG DWF66 Reset Procedure?
Ha – it sort of works on the wife’s SupaPuta – you’re stuck in the test cycle – the “C” codes are used to indicate progress through this. Unfortunately, it’s as clear as mud how to get out of the test cycle 🙁 .
Penguin45.
