Forum Replies Created
-
Posts
-
Re: WTA Commitee – Elections for 2009/11
Further to the above statement, I am advised that Ian Dales will not be in a position to join the WTA Commitee.
We therefore invite nominations for two new Commmitee members.
Apologies for any confusion caused,
Chris Chantrell,
Secretary to the Commitee,
Whitegoods Trade Association.Re: AEG Competence B4100-1 Cooling Fan Keeps Running
Cooling fan function is controlled a small thermostat on the back of the oven casing. This may well be sticking. Part number is 3873118008, spares@ukwhitegoods.co.uk for pricing and ordering.
Power off if you intend to fit this part yourself.
Penguin45.
Re: Whirlpool AWO 3551 HELP!!!!
If the machine got started (filled, started to tumble?), the next step is heat, so the problem may well lie with the heating element.
Power off if you intend to sort this out yourself.
Penguin45.
Re: September 2009
Have now received mail from Ian stating that he does not wish to stand for the WTA Commitee………
Chris.
Re: Creda gas oven 48132 not relighting
As per the STICKY at the top of the forum which no-one ever reads, we are unable to advise on gas appliance repairs.
Please contact your local Corgi/Gas-safe registered repairer for assistance.
Penguin45,
Moderator.Re: Electra AWM1100Beco not heating up
Door seal is HERE. This ARTICLE will help you in the future.
Heating element when metered (with the plug out) should read 20-25 ohms when the wires are removed. Replacement can be found HERE if required. It’s a bit of octopuss wrestling to get the old one out but basically straightforward.
Motor labouring is often a capacitor issue. Check the “uF” rating on the one you’ve got, then choose from HERE. It’s the 20 uf one from memory but check first.
Electra was the old Electricity Board brand name. They’ve been gone for some years now, so a manual will be unobtainable through any official channels.
Power off if you intend to work on the machine yourself.
Penguin45.
Re: In search of the fourth cord
It’s in the Trade Forums – let them slug it out IMO. SB’s put himself up to be shot at……
Chris.
Re: Hotpoint WF541 Drum Bearing
Correct – they’ve got you……
You may like to have a read and a think about THIS ARTICLE.
Penguin45.
Re: Smeg Dishwasher not emptying at end of cycle
Drain pump/sink coupling blockage, failed drain pump.
Model number please if you need more specific information.
Penguin45.
Re: Hotpoint WF541 Drum Bearing
Sealed tub……..
Tub assembly is p/no C00143604.
spares@ukwhitegoods.co.uk will give you a price for it if you really want to repair it.
Penguin45.
