Forum Replies Created
-
Posts
-
Re: Bosch table top dishwasher problem
The chamber should only drain down when the solenoid valve (bottom right in picture) is activated. If it is slowly draining down, the valve is leaking and should be replaced. P/no 065539 – spares@ukwhitegoods.co.uk will be able to supply one for you promptly.
Penguin45.
Re: Whirlpool American Fridge Freezer side by side
shaechi wrote:Its a whirlpool, any suggestions?
Giving the fridge lads a model number would be a good start……….
Penguin45.
Re: Hotpoint BF1680
If there is a water leak into the outer sleeve, the red inner tube will make the whole outer tube appear to be red.
Chris.
Re: Smeg Dishwasher DI612C Disp Coil or PCB?
PCB, Laurence. You have had a peek at the suppressor as well?
Chris.
Re: Hoover HD97E dishwasher E1 fault.
It’s got to be water level related. Pressure chamber is a take-off on the front of the sump – sludged? There’s no flow meter on this one to worry about, so slugde, water in the hose and p/sw or p/sw itself I suppose – ain’t much else.
Chris.
Re: UKW search facility.
‘sex AND travel’ …….. 😀
Actually, you could just use ‘goldstar AND …..’ to generate results. It’s a but clunky, but it does work.
Chris.
Re: F&P GW712 Does Not Spin Error Code 10000010 (130)
It’s the Rortor Position Sensor (RPS) error. Usual problem is wiring – wet, corroded; bent tags in the terminals or damage to the RPS itself. In extreme cases it can be the motor controller board.
Penguin45.
Re: Bosch sparepart alternative?
Everybody stop. Take a deep breath….. and exhale.
Right. Information is provided to members of the public by professional members of the UK repair trade. Almost without exception, we will fit suitable manufacturers parts or a like for like alternative – from a trade wholesaler with a known track record. The actual specification of any given component is of little interest to us – we just need to fit another one on a like for like basis.
A member of the public has an option which we don’t – time. If the OP has the time to try and save a few Euros good luck to him; it’s a luxury that we pros just don’t have.
Penguin45,
Moderator.Re: The ignore button
Press it again, it’ll bring up a list of those you have chosen to ignore. Press the cross to un-ignore.
Chris.
Re: Ariston A1535 completely dead
C00047317 is the part number for the brushes to fit your motor. They don’t seem to be in the Shop@ facility, so drop a line to spares@ukwhitegoods.co.uk for prompt service.
Penguin45.
Re: Caple CR903SS cut out thermostat
It’s a one-time safety cut-out for use in the event of oven thermostat failure. However, if your element went with a bang, it may have been knocked out. Fit a replacement and check that the oven thermostat does actually cycle the heat at various different temperatures.
Penguin45.
Re: NEW ISE 5 ?
There will be no direct replacement of the ISE5, or the ISE2 for that matter. Due to the collapse of the pound against the euro it has become impossible to keep the machines in their appointed slots in the market and maintain profitability.
The new machine is called the AW23 and will be available to purchase with either a 2 or 5 year warranty as the customer wishes. It has a 6kg load, 1400 spin, three legged suspension system on a rugged chassis and a very clear info screen.
Prices are to be finalised shortly, ready for launch in April.
Penguin45.
