Forum Replies Created
-
Posts
-
Re: Bosch SRS43C12GB Slimline pump problem
No internal access on this one, SM.
Drain pump is a twist fit; side matrix unclips and lifts away.
Penguin45.
Re: 08/09-Football Season Arsenal free zone.
iadom wrote:Spurs put up a good show against Uniteds reserves, plus Ronaldo, Ferdinand and Evra.
Playing against 14 would explain a lot……. Anyway, we thrashed you 0-0 for two hours before the unfortunate episode after the game.
😀 😀
Chris.
Re: Bosch SRS43C12GB Slimline pump problem
Drain pump is accessed by removing the lower front cover plate. It’s a twist fit. Removing door outer panel makes it a bit easier. From your description, it sounds like the pump is actually running, so it is possible that there is a blockage in the matrix (the rear two tubes). Consider that a bit of broken glass will be invisible in the water.
Power off first.
Penguin45.
Re: Zanussi Aquacycle (Essential) 1600.
ZWF1621W.
Tech file should be landing in your in-box any moment.
Chris.
Re: Neff B1430 oven door in bits
You need a tube of THIS STUFF.
Strip the old sealant off, clean and degrease surfaces thoroughly and use plenty of the sealant to re-attach the glass. It need weighting into place for 24 hours to achieve a proper bond.
Penguin45.
Re: Help Bosch dishwasher Timer dial getting stuck
Check where the wiring loom hinges under the tub – remove door outer for access. Broken wires were a common probolem. Otherwise, if it hangs at exactly the same point every time, it may well be the timer.
P/no 092127, around £85 – may be a slightly debatable repair on a machine of this age.
Power off if you intend to repair this yourself.
Penguin45.
Re: Creda Dishwasher stopping Mid-Program
Timer failure is possible but unlikely. Problem probably lies in the wiring loom at the pivot point of the door.
Power off if investigating this yourself.
Penguin45.
Re: Indesit WE16s Heating Issue
The PCB fas failed. Constant fill/drain doesn’t happen as part of a programme – there is either a logic problem or burning on the fine tracks from the triac array. F8 is a heater relay issue, also part of the PCB.
At 6 years old, this is positively ancient for an Indesit, so probably time to move on.
Penguin45.
