Forum Replies Created
-
Posts
-
Re: GE Dishwasher BF41 Not Heating Water Or Moving On
Rubbish – the safety will trip due to underfilling. Remove and clean out the three hoses running across the bottom of the machine to solve the problem.
Power off first.
Penguin45.
Re: Bosch Classixx Dishwasher draining/reset question
You have accessed the drain pump. Under no circumstance invert the machine.
Define “not fully draining” – there will always be 1/2″ of water left in the bottom of the sump.
Penguin45.
Re: Minutes of Meeting – 26.2.10
As usual, I have managed to post the un-amended minutes – this is now corrected. I would draw your attention to point 2/ e) which was omitted and the addition of the chairman@ email addy.
I have corrected all names seeing as you’re all in a sarky mood…..
Chris.
Re: White Knight 447WV
Approx 23 ohms per heater when split from the circuit – power off first.
Penguin45.
Re: CDA CW448 – Leakage & Error Codes
Last time, it was flooded in the tray underneath – tipping it re-set the float switch and allowed it to work. You really need to get the covers off and find the leak.
Penguin45.
Re: BOSCH WFL2450GB/01 heater?
Front panel off – 2 screws at the bottom, one in the soap drawer opening. Slip band from door seal and release it, whole thing will come away.
Penguin45.
Re: Candy DFI 50
Machine should stop filling when the pressure switch is activated. The secondary hose to the valve operates a pneumatic shut-off.
Possible problems are water in the pressure hose/switch, or the air collecting chamber is full of crud.
Penguin45.
Re: F&P GW709AU not filling problem
Cold water valve should read approx 64ohms if you measure the resitance with a test meter.
Penguin45.
Re: AEG 72630 – removing motor
Just lever the motor towards you and it’ll pop off. Usually quite abruptly, so mind your toes….
Penguin45.
Re: aeg f65051a
It’ll have to come out – r/h side panel and rear lower cover off for access, then a couple of spring rings.
Chris.
