[ray.t]

Re: Hotpoint Vtd00 Dryer

Hi I dont think the noise is from the back. I have tried it with 1 washer worked ok for 1 load before it started making the noise again. I went back fitted 2 washers and again it was ok for a load or two before it started again. I have in the past come across the drum rubbing the back but this seems to be coming more from the front. I have had the machine apart about 5 times in total and every time I put it back together its ok but only for a short time. I will try and record it and get my son to put a vid up.
Thanks,
Ray

[ray.t]

Re: Hoover HNWL6136-80 N: 310008970687965 door handle/latch

I dont have a pic mate but I think this one uses the outer door frame for the spring to push against, so until its back in one piece you wont get any tension.
Ray

[ray.t]

Re: CDA CI992

One more,

[ray.t]

Re: CDA CI992 (now with pics)

Thanks for that I will give it a try.

[ray.t]

Re: Hotpoint BFI680 Hose clips

I do yes,
18-25mm HFX382 item code 971507
25-35 and 27-40mm HFX384 item code 971523
They were on the rack with all the car fuses scotch locks and that sort of stuff.
I used them for a Kenwood dishwasher so not sure what size you would need for the hotpoint. They are 9mm wide
Ray

[ray.t]

Re: Hotpoint BFI680 Hose clips

Hi, I had this problem the other week, went to all my local motor factors and none of them had anything like it.
My local Halfords had a range of thin jubilee clips, worked a treat.

[ray.t]

Re: Stoves Range cooker 200564131 sn11100828

Thanks for that, I will get a kit and see how I go.
To change it does the top come off or do you get access from the side panels?
Thanks,
Ray

[ray.t]

Re: indesit IS70C tumble dryer

I did one of these a while back. I drilled through the points were the screws would normally be, didnt take much drilling to remove and just screwed on a new shaft.
Ray

[ray.t]

Re: Aeg Washer Dryer, L12700VIT Prd 914601902

Thanks for the advice on this, I am never going to find out as the owners are going to buy new.
Cheers,
Ray

[ray.t]

Re: Miele W864

Thanks for that, nice and cheap then.
Cheers,
Ray

[ray.t]

Re: hotpoint bwm129(integrated)

I use a pair of long nose pliers and plenty of wd40 and they go on ok.
I know what you mean though, the first one I did took about about an hour to do.
Ray

[ray.t]

Re: hoover PE235 stops after spin on rinse

Had one like this the other day, the small plug on the bottom of the timer had just come out a bit. Pushed it back in and it worked fine.
Ray

[ray.t]

Re: Zanussi Zwf16070w1

Hi I tested it again it filled and washed ok pumped out fine and got stuck again just on drain.
I think it is a problem with the pressure switch, I have ordered one and I will post with the outcome.
Cheers,
Ray

[ray.t]

Re: Zanussi Zwf16070w1

Hi I have put this machine through the diagnostic check and have come up with an error code of E69. I cant find that on the list of codes though, strange thing is though it seemng to be working now.
Dont you just love this type of machine.
Cheers,
Ray

[ray.t]

Re: Zanussi Zde57140w dryer

I do, Thanks very much.
Ray

[Author]

Posts