Forum Replies Created
-
Posts
-
Re: Neff Dishwasher fill problem
Thanks again Martin. The water starts to leak out within 5-10 seconds from the spill over. Approx how long is it between the initial spill and when the wash pump kicks in? Just a stab in the dark here but does the water softener pull some of the water in at this stage to divert some of the pressure?
Re: Neff Dishwasher fill problem
Fitted 263186 just to see if machine behaved any differently to the original pressure chamber. Totally stumped me , this one. Pressure chamber cleaned, sump tube cleaned, tub vent clear.
Re: Neff Dishwasher fill problem
Returned today to machine and fitted 263186 which also had the rubber gasket fitted along the top. Result was pretty much the same except the water was now back feeding up to the top vent hole on the heat exchanger. :bang:
Re: Neff Dishwasher fill problem
I’ve tried it with the door latch tripped opened, in case it was a venting problem. I have removed the short pipe and cleaned, although it wasn’t clogged. Checked the pipe connection in the sump. Could the black insert in the pressure chamber be causing a problem. I know other models don’t have this fitted!
Re: Neff Dishwasher fill problem
Thanks for the reply Martin. As far as I can remember, as soon as the water starts to spill into the pressure chamber it gluggs away and small amounts start to leak out of the top. I’m not sure when the wash pump kicks in but I would say the timing seemed no different to usual.
Re: Smeg A2-2
Masterpart showing alternative of 818731025 in stock. Checked with Connect and both numbers refer to the same part.
Re: Hotpoint Minstral FF72P PCB part PTC1?
Rs 198-848 is now discontinued and replaced with 191-1816
Re: One for the ‘Smegheads’
Try this link
http://www.smeg-service.co.uk/shop/inde … 202&page=1Hope it helps!
Re: famous customers?
Reg Varney, Peter Simpson, Geoff Love, Linda Davidson (Mary the punk in eastenders) Steve McFadden and Ray Winstone and Jamie Winstone(pre fame) spring to mind.
Re: Bosch Auto WAE2416SGB/04
Hi Martin, Not replaced door lock as yet. However I discovered if I removed the small 2 brown wired connector from the pressure switch, then turn machine on, the door will lock but with still the same outcome. Have discovered a previous post with exactly the same symptoms with diagnosis of pcb.
Re: Electrolux ER3201B defrost stat
Ouch 😯 I see what you mean. I don’t think the customer is going to stretch or wait for that. Thanks for the reply anyway.
