[robbo1973]

Re: Samsung F/F RS20CCSN

the fault will be with the heater in the fridge i have had this fault loads be sure to disconnect tray heater when testing.

chris.

[robbo1973]

Re: wia 101

thanx for replies i have ordered the book.

cheers chris.

[robbo1973]

Re: wia 101

i know what you mean re the fault codes but it is sometimes a nice pointer. i have had a couple also one not resetting which was board the other a different combination of lights which has been sent away.

hope fully someone will have them i have read about a hardware key which gives you the fault dont know if there any good ❓ .

[robbo1973]

Re: whirlpool s25brsb31-a/g

you had my hopes up there but it takes me to the log in page 😥 .

any ideas chris.

[robbo1973]

Re: whirlpool s25brsb31-a/g

any one got any tech info manuals or anything on these w/pool american f/frzrs ❓

[robbo1973]

Re: whirlpool s25brsb31-a/g

could do with a w/pool expert on this one no takers. ❓

[robbo1973]

Re: Servis M6005 Door

the pecker has a slot (hard to explain) which fits either side of the bar going across the handle which generally snaps cleanly. defo moves the pecker.

[robbo1973]

Re: Servis M6005 Door

the handle does move the pecker so if it isnt the bar across middle of handle will prob be broken. fit a new handle kit but put a little bit more tension on the small spring as sewrvis had problems with starting these machines.

[robbo1973]

Re: Samsung SRS 2028 DVW

prob heater when it cuts out it is relying in ambient temp to defrost evap rather than heater coming on.will stay off for ages when you turn off and back on it resets it. check heater and thermal fuse etc.
hope that helps.

chris.

[robbo1973]

Re: zanussi zx99sw

thanx for reply andy any part nos etc handy. if not is there just one thermistor or more like on a hotpoint ❓

[robbo1973]

Re: AEG Washer L10500V1 dying display

if this is a zanussi then check the edge connectors on board i have had this problem before. but i am sure a zanussi expert will let you know on here.

thanks chris.

[robbo1973]

Re: candy FF too cold

never changed one i think the fridge one is foamed in pretty much zero failure rate on both though.

[robbo1973]

Re: servis firdge freezer

he says the freezer is cold so the compressor must be running just not at full capacity it stat was o/c there would be no cooling. if it was f/free it could be circ fan.

[robbo1973]

Re: servis firdge freezer

if it aint frost free then it sounds like a system problem compressor,blockage,leak etc.

[robbo1973]

Re: candy FF too cold

had this before it is generally the board at fault. sometimes the interior light blows as well.

chris

[Author]

Posts