robbo1973

Forum Replies Created

Viewing 15 posts - 571 through 585 (of 644 total)
  • Author
    Posts
  • in reply to: smelly fridge #224840
    robbo1973
    Participant

    Re: smelly fridge

    generally find if you look in gasket at bottom of fridge spillages milk etc gather in there i go to quite a few where the cust has cleaned it turn the seal back and show them the gunk.

    in reply to: indesit wia121uk #224296
    robbo1973
    Participant

    Re: indesit wia121uk

    thanks for replies lads.the lights are door locked, there are 2 option buttons on this machine and i think it is the right hand one and it has 3 progress lights away from option lights and the rinse is the middle one.

    thanks chris.

    ps quite a new machine about 1 and a halfish she thinks it does not have the normal rubbish board at the bottom corner but a main board behind front facia.

    in reply to: indesit wia121uk #224293
    robbo1973
    Participant

    Re: indesit wia121uk

    no takers are there any fault codes or do i need hardware key ❓

    in reply to: wia 101uk #224728
    robbo1973
    Participant

    Re: wia 101uk

    thought so cheers. any idea on fault codes on these ❓

    in reply to: sat nav #224082
    robbo1973
    Participant

    Re: sat nav

    thanx for replies 😀

    in reply to: split cab zanussis door seal replacement. #223675
    robbo1973
    Participant

    Re: split cab zanussis door seal replacement.

    i fit htese no probs in about 10 mins but have to use plenty of washing up liquid and slide it on. 😀

    in reply to: belling xou499ss/1 #223134
    robbo1973
    Participant

    Re: belling xou499ss/1

    thats what the customer says and the fan was running as well. it happened to his wife first then he tried it and it did the same. he ran it for about 10 mins switched off stat and selector and it continued. i was there ages and nothing. 😡

    in reply to: servis washer dryer – soap drawer #222728
    robbo1973
    Participant

    Re: servis washer dryer – soap drawer

    make sure she is putting it in correct compartment if she is only low water pressure will cause this i would think.

    in reply to: Brandt Hob Problems – Is this Induction? #222656
    robbo1973
    Participant

    Re: Brandt Hob Problems – Is this Induction?

    depends how old it is if this appeared suddenly and she has used this pan before then there is a fault.if it is an induction hob and she has just got this pan it may not be compatable with induction hobs. if a neon is coming on she has supply check links in term box on hob can knock rings off.

    good luck chris.

    in reply to: Samsung Fault #222473
    robbo1973
    Participant

    Re: Samsung Fault

    water leak i would think faulty valve like on a washer the ice poss same or the sensor under the tray :?:i would like to know what out come is as i am going to aleaky one in a couple of days.

    in reply to: samsung rs20ccms -NOT THE USUAL!! #222440
    robbo1973
    Participant

    Re: samsung rs20ccms -NOT THE USUAL!!

    normally the freezer evap will be frosted up always defrost sensor at fault change that and should be fine done loads. i am sure this is the older set up and not the newer as you said with a fan at top of freezer forcing air into fridge.

    in reply to: Kitchenfitters tricks! #222349
    robbo1973
    Participant

    Re: Kitchenfitters tricks!

    had a built in fridge a while back but couldnt budge it then noticed that it had beeh link screwed to the freezer next to it with flat metal plates which had then been screwed to the TOP of the units then the worktop fit.unbelieveable 😯 ..

    in reply to: SERVIS M9310 W/D built-in.. #222242
    robbo1973
    Participant

    Re: SERVIS M9310 W/D built-in..

    normally just a dry joint on board you can generally see it i have re soldered loads of these. 🙂

    in reply to: ocean badged f/frzr #221486
    robbo1973
    Participant

    Re: ocean badged f/frzr

    any phone numbers never dealt with these b4 do you need account.

    in reply to: Large capacity drums putting holes in clothes? #221212
    robbo1973
    Participant

    Re: Large capacity drums putting holes in clothes?

    i have been to a servis 6kg today with the imprint of the drum and little holes on some of her whites.i didnt know what to say as drum checks fine and bearings solid.any other advice.

Viewing 15 posts - 571 through 585 (of 644 total)