Forum Replies Created
-
Posts
-
Re: AEG T59840 Tumble Dryer
Filters, filters and filters, good hoovering normally brings them back to life. Just be aware they can take 3 hours to dry a full load.
Re: Beko Freezer evaporator icing up TZDA 568 w
Power off when doing any testing!
If you take off the evap’ cover you can see defrost heater and any other components that you wish to examine.
Re: beko dsfn1530 manual
Small wiring sometimes breaks in loom at bottom of door, fine wires to NTC & water counter are particular problematic, hard to see the damage, but a little tug will prove the break.
see similar prob’ here…
dishwasher-forum/beko-dw686-not-heating-the-water-t86485.html
Re: Beko DFN1000X
Check loom for breakages of tiny thin cables, they are prone to damage, not always visible but a tiny tug on them will reveal the breakage.
Re: Beko DW602 Dishwasher
P.C.B possibly faulty. They do give problems, mostly from steam condensing on board, likely caused by poor fitting of door.
Re: BEKO CDA556FW – Need advice. Fridge is freezing
I think that theres a thermistor embedded in the fridge rear wall, if it fails the appliance reverts to timed cooling instead.
Defrost timing is incorporated in software of rear p.c.b as far as I know.
Early ones had defrost timer located near compressor.
Its likely if there is a patch appearing that either the gas is low & struggling to cool all the back wall of fridge therefore not getting cold enough to switch off or there could be a breakdown in insulation.
Re: beko dcu8230 condensor dryer
Seamy wrote:I’ve never had to take out the motor, all can be done through opening of vent outlet.
:boops: Sorry lads, my mistake this is condenser version, I was thinking about the vented version
Re: beko dcu8230 condensor dryer
I’ve never had to take out the motor, all can be done through opening of vent outlet.
Re: Beko DW686 Not heating the water
Check NTC & wiring to it.
:eeek: please don’t do live testing :eeek:
Re: Zanussi ZKC5030 no power to main oven
No internal fuse as far as i’m aware. Normally element replacement would be all you need, but sometimes a blown element takes out trip or fuse. Have you checked house fuseboard, is there power to theactual oven?
Re: Beko going into full speed spin immediately.
Good on ya, I never go down to component level, but i’d imagine its a triac that is shorted, not definite though as i’ve never tested any of them.
Re: Stoves 444441654 induction
E / 2
Excess temperature of the induction element
Overload of cooktop or empty boiled cookware
Let system cool down.
