Forum Replies Created
-
Posts
-
Re: Miele WS5427 What’s all the extra tubes and wiring?
Likely they are to bring in detergent.
Commercial or semi commercial appliances will sometimes have the facility to be operated by coin mechanisms as
in a laundry for instance & to take liquid detergent from a bulk container mounted near the appliance.Re: MIELE D/W G653 SCVI
Check the pressure switch on wash pump, after it starts it looks for this pressure switch to be made before it will move on, this is to prevent the heater being switched on without water in. If there was a blockage in the impellor for instance it may cause problem described.
Re: Energy Reg Switch For Zan ZKC5540X Cooker – See Photos
Yeah theres a rewire to be done on it, if you take the red switch, wiring was from shaft:- black, white, red, blue.
On the new white switch change black & white aorund, so from shaft side, it will be, white, black, red, blue.
Re: Miele Dishwasher G 5985 SCVi XXL fault code F 79
Don’t know of a F79 fault, F70 means water in base,
Re: Miele T490. Not heating.
Yes it would prevent heating, you can try it in timed drying to test heating though.
Re: Zanussi FJDR bearing change – removing pulley
They are held in place by LockThread or similar. A hex on a socket driver is normally the best to shift them, once you crack the LockThread it should come off o.k.
Re: Zanussi ZDC37200w
Have you tryed getting the alarm codes in diagnostics?
It could be going off because theres no clothes in dryer, most sensor type dryers will cut out after a few minutes if the detect no damp clothes.Re: Miele W340 washing machine, changing motor brushes
Front panel off, all done from front, motor brush module comes off from front of motor without taking complete motor off.
