Forum Replies Created
-
Posts
-
Re: Beko dwd4310w
NTC is pushed up from bottom, taken out by turning 1/4 turn. Check relay on p.c.b, they’re prone to bad contacts & sticking.
Re: John Lewis JLUCFRW6004 FridgeFreezer Compartment. Any go
Electrolux appliances are normally rebadged for John Lewis, in fact their washers are A.E.G, not sure about the Refrigeration though & don’t know this model though.
Re: Zanussi ZX97/5Si How to get to the evaporator part
If its a ZX97/5Si it should have a circuit board. Theres two listed for them in parts diagram for every version, a display circuit board & a main control circuit board.
But of course it may not be the problem, fan is likely slowed up or jammed as cpt’ has posted or defrost circuit is faulty. Fan is at back of cooling evaporator at top of freezer cabinet, not easy to ascess. Careful you don’t damage cabling or pipework getting to it.Re: AEG Electrolux Lavamat 66819
Drain pump 1322082007, is same as 1323239002 :- http://shop.ukwhitegoods.co.uk/pmp239-w … drain-pump
Circulation pump is part num’ 1105797011 :- http://shop.aeg.co.uk/product/110579702 … 2CCOMPLETE
Re: Electrolux bs68/01 oven
Theres a part called “cooker end cap selector switch” part num’ 3110538000 which I presume is the selector switch that the t’stat piggy backs onto the rear of.
Re: AEG B-2190-1 Tripping out the RCD in Fusebox
Fan control fuse? Do you mean the thermal cut-out?
Hard to tell without testing, but likely its the lamp unit or element shorting to earth. :lesson: Power off if doing any testing or checks of course.Re: John Lewis JLFFW2013 problem.
Maybe fan problem, fan in freezer blows cold air up to fridge via ducting & past a motorised flap actuator that opens & closes depending on temperature selected.
Re: AEG Electrolux Lavamat 66819
Agree that with an error code E20 it points to pump problem. Appliance can show up motor fault on long programmes as motor could out on high temperature cut-out, this seldom happens on low temp’ shorter washes.
Pump 1323239002 would do the job for you i’d think, is it the same as this?
http://shop.ukwhitegoods.co.uk/13220820 … drain-pumpRe: AEG Electrolux Lavamat 66819
How many times does it flash?
Its could be the main motor is at fault or 3 phase supply to it, than the pumps, i’d think.
Count the flashes (beep beep alarm) & report back please, it will help to identify the problem.Re: Miele tumble drier (T4262C)
If you open the door during the cycle is it hot inside, e/g is heater on? There could be a blockage of the ducting/fan & its not circulating hot air correctly.
Re: AEG Electrolux Lavamat 66819
Circulation pump should start up after filled to correct level, not heat dependant.
When it skips to end does it flash & if so how many times? When you say that the clothes are soaked at the end it may point to motor error.
Will it spin on full spin position?Re: AEG Lavamat Turbo L16830 – Which PCB?
Yeah an ohm meter normally won’t pick up an earth fault on the drier element, if its reading 1.5Mohm across to earth its likely thats causing the problem. I you take note of the cables position on the heater, take them off, tape them up. Try appliance on wash programme without drier heater in circuit & see does it go through programme without bringing up error codes.
Re: AEG OKO Favorit 6040 not filling
Part number for circulation pump is 8996464034579
not cheap though, if you can find one.
