Forum Replies Created
-
AuthorPosts
-
Simon46
ParticipantRe: Zanussi T/D TCE7124W
Dont have TDS but if this is the one with the start button and complicated interlock i have had a coil in the interlock melt due to tea spilled down front.
Regards
S.November 27, 2005 at 12:01 pm in reply to: Replacement Slimline Dishwasher – Recomendations? #155695Simon46
ParticipantRe: Replacement Slimline Dishwasher – Recomendations?
Bosch. Repairs@ should be able to help you.
Regards
Simon.Simon46
ParticipantRe: Homark 05-703105A1X Fan oven element pattern
Thanks Dave
November 24, 2005 at 11:11 pm in reply to: Bosch SMS9022GB/11 Dishwasher timer clicking continuously #155448Simon46
ParticipantRe: Bosch SMS9022GB/11 Dishwasher timer clicking continuousl
Doorloom o.k. Damp garage for a while. Thought switchbank as if reset is being pressed or something like that.
S.
Simon46
ParticipantRe: Hotpoint 8596p fridge not getting cold
Evap thermistor first. Unplug before working on it :zap: . Check out Shop@ for part or repairs@ for an engineer.
Regards
Simon.Simon46
ParticipantRe: Hotpoint FF92BL – Thermistors
Evap thermistor is the most common fault. Unplug before looking inside :zap:
Regards
SimonSimon46
ParticipantRe: Fridge/Freezer-freezer suddenly not working!
Philip check your email.
S.
Simon46
ParticipantRe: Servis 3001 won’t drain – funny noise
Sounds like the drum shaft bearings have failed. Check the drum for up and down movement (loose). Power off before going inside :zap: . Check out Repairs@ or directories for an engineer in your area.
Regards
SimonSimon46
ParticipantRe: Fridge/Freezer-freezer suddenly not working!
Usually sensing is done in fridge which needs to defrost after every cooling cycle. If the fridge never reaches defrost temp then the fridge will not switch on. If the motor is not running the freezer will also not get cold.
Very common reported symptom at this time of year.
Regards
Simon.Simon46
ParticipantRe: Down to earth cooker elements
Had similar problem with my own Creda panel heaters i bought as a job lot out of a cold garage. The shiniest unused one trips after 5 mins. After running elements for thirty minutes in vice (No earth) 😯 and not touching them whilst plugged in it has worked fautlessly for months. Hope this helps.
Simon.
November 21, 2005 at 3:50 pm in reply to: Smeg UK80MFX cooker-fan element replaced-only reaches 180c #155029Simon46
ParticipantRe: Smeg UK80MFX cooker-fan element replaced-only reaches 18
Is the oven fan assisted? If so is the fan rotating?
S.
November 21, 2005 at 2:15 pm in reply to: Smeg UK80MFX cooker-fan element replaced-only reaches 180c #155026Simon46
ParticipantRe: Smeg UK80MFX cooker-fan element replaced-only reaches 18
Have you got an oven thermometer to test temp? Or is it cooler than it was?
Regards
SimonSimon46
ParticipantRe: Zannusi FJS1225 Burning smell
If this is the one with jetsystem is the pump running?
S.
Simon46
ParticipantRe: Hotpoint Super Plus 7821
Or broken wiring in door. Unplug if you are going to look yourself :zap:
Regards
SimonSimon46
ParticipantRe: Ariston AIB16 Door Not Locking
If you are talking of the screw in filter it is very important. It helps create the vortex for the drain pump to operate. Can be ordered from the shop@.
Regards
Simon. -
AuthorPosts
