Forum Replies Created
-
Posts
-
Re: Help on old Zanussi washer
Not a button/coin in drain hose acting like a shutoff valve when pump is operating? If that pump worked the new one should too.
S.
Re: Diplomat APM 8512 Washing Machine
The only things you can check are the filter really. This will have to be diagnosed by an engineer. Check out Repairs@ on LHS of page for one in your area.
Regards
Simon.Re: Hotpoint BF162 D/W light No:2
Yes i have one BFI 62 in the garage. Faulty board due to cust using a screwdriver to press the fallen out P button switch. Replaced board now 2nd light is flashing. Heater was O/C as well. 😥
S.
Re: Hotpoint Mistral: Display/No display boards
It was only going to be for test purposes due to compressor only running for a few minutes.Was not required.
Fault found to be foam strip stuck in condenser fan jamming it.
Another new fault cured. 😀S.
Re: Bosch SGS6342GB/07 Dishwasher Blown board Tracks
Thanks Chris. Will check heater motor etc. If it has run for hours i suspect fried motor.
S.
Re: WMA 20P replacement Drum /bearings
Hooray its done. Midnight oil. And a Repairs@ e-mail awaiting attention.
😀
S.Re: Coca cola fridge thermostat
Bryan out of interest for next time how much are the fridge air thermostats?
S.
Re: Coca cola fridge thermostat
Thanks Tony
Unfortunately it was the compressor.
Will have to pay for Bacon and Egg now. 🙁S.
Re: WMA 20P replacement Drum /bearings
Thanks Iadom. Will try to get hold of a tub for next time.
The seal joke i only got in the van today (bit simple) Chris. 😆S.
Re: WMA 20P replacement Drum /bearings
Those 3 spider bolts are a pig. One drill bit per bolt destroyed and two T27 bits snapped (Halfords professional). Tried the Blowtorch on bolts, cooling with WD40. Plenty of creaking noises but will not budge. Jewellers screwdriver/WD40 to remove torx bits from head. No bolts in stock at supplier. Promised Cust del tomorrow. Doorseal holed near interlock rub. Oh no!
Apart from that Job is straightforward. 😆S.
