[Simon46]

Re: Hoover HND6515

Could i have a copy too? Got one no heat.

S.

[Simon46]

Re: Hoover WE140 Bearing kit

A nightmare washer dryer i know. But im doing nothing else so off we go.

S.

[Simon46]

Re: Diplomat dishwasher 6 flashes.

A bit older than me u are. 😆

S.

[Simon46]

Re: TECNIK TKL 9290

Have a look here
http://www.ukwhitegoods.co.uk/modules.p … ght=siltal

S.

[Simon46]

Re: Ariston AWD12 – not filling

It should have shown FO2 (two flashes) as brushes were failing on spin/ wash and dial clicking round. when no contact any more machine does not start.

S.

[Simon46]

Re: Ariston AWD12 – not filling

Meter thru brushes across armature power off of course. Or just remove and inspect length.

S.

[Simon46]

Re: Ariston AWD12 – not filling

Or the motor brushes. Door locks, no action.

S.

[Simon46]

Re: zanussi jetsystem 1250 clock/ programmer stop

how many times does it have to be moved on during cycle?

S.

[Simon46]

Re: Whirlpool ADG722WH program issues.

long shot but plug in mains socket ok?

S.

[Simon46]

Re: Diplomat dishwasher 6 flashes.

Sometimes i just transfer PCB from newmatrix to old for an easy fix.
reed switch stuck. no pulses on meter when magnet passes wheel during filling.

S.

[Simon46]

Re: APM6855 fridge temp – again!

Only a multimeter will tell the condition of the parts out of circuit.
Power off if you are going in.

S.

[Simon46]

Re: Moffat MSF615X overheating after thermostat change

Is it wired correctly?
Power off before going in.
S.

[Simon46]

Re: Soldering Guns

Dont forget to fit a thermal fuse rated 3000 degrees first before defrosting 😆

S.

[Simon46]

Re: Hotpoint TDC30 -not heating – new stats & element

Only a multimeter will tell if faulty set to ohms. 😉 . Power off before testing.

S.

[Simon46]

Re: Hoover HFA290GB

This could be one that when the PCB fails it runs all the time if no lights on module.

S.

[Author]

Posts