Forum Replies Created
-
Posts
-
Re: Whirlpool comercial dryer 3RLEQ8033SW1
replaced one of these yesterday , fairly straight forward plenty of access , the fan chamber wasnt blocked but there was a thick layer of fluff on the surface which in theory could get hotter than normal , im sure we’ve all seen the singed fluff in the heater cover on the domestic stuff
Re: indesit WD12X UK flashing led dial turning
problem with this m/c is it doesnt always flash the red led when the dial is moving around the clock , i had the cust. put on 3 cycles and none had a light flashing just stopped and dial moving all the way around
Re: zanussi DW908 stops mid cycle
ah yes switched neutral mike,220v power to the pcb and then switched using a relay to the element thanks for that
Re: zanussi DW908 stops mid cycle
i have to refer back to the original post , the problem being it has 220v going to the element but its cold , i cant see how this problem is something to do with the pcb , it has power at the element terminals , i didnt measure amperage but surely that wouldnt matter it has 220v !has to be carrying current also right ?
Re: zanussi FLS883W stopping midcycle
checked all the obvious mike , customer decided to go for a new m/c as this one was 15 yrs old , it just loses power to the timer at the same point midway through i decided it was the timer so he went for the new one cheers kieran
Re: whirlpool awo/d 5706 outer drum cracked !
ha some good feedback guys , it didnt shake about or make any unusual noises she said just kept leaking , could this be faulty materials ?
Re: whirlpool awo/d 5706 outer drum cracked !
cant understand what could get through the inner drum to do that damage ? customer said she had a repair man in a few months ago to replace a heater element !
Re: hoover SV23 001 low heat
checked switch its working fine i dont understand how the element has continuity between both parts of it , there are 2 seperate rings 4 tags like a grill element !
Re: hoover SV23 001 low heat
poss Martin , i didnt take it out or check it for operation but there was power going to it i dont remember how many wires were going to it , i guess it just sends the power in both directions to heat both parts of the element when on high , could be that i spose , cheers i will check
Re: siemens SE25A831GB/17 no heat
had another go at this , no power coming to the motor from the control board to start it when filling , no power going to the pressure switch either , all cycles starting to fill but thats all , motor windings ok, wiring looks fine no chaffing at door and all hoses clean took out control board and it looks ok also , no burning or any visible marks all connectors attatched and secure , looks like board prob though
Re: beko DRVS 62W noisy drum
on further inspection of this it turns out the motor is also making noise , loose bearing on the shaft, belt end customer scrapping m/c
