Forum Replies Created
-
Posts
-
Re: oven overheating
this woman is using her domestic oven to run a baking company its only small stuff but i’m nearly sure she is overloading the oven cavit y , i’m just gonna see how she loads the shelves and take it from there thanks for the reply martin
Re: hotpoint FF40 lights flashing and beeping
i tried hotpoint for a partfinder disc and they couldnt get one , im not worried anyway i think the problem is oibvious enough , the water after being defrosted is not runninig down the gutter into the catch tank on top of the comp. it is staying in the plastic housing and running down the back of the freezer wall into the well under the bottom drawer . result drawer frozen in place . i have seen a few posts on other sites with roughly the same problem only on a ff200 model , the solution seems to be to get an uprated wiring harness and gutter heater for the defrost heater , problem is i cant find this anywhere anyone out there have any info on finding these parts thanks k 🙂
Re: hotpoint rf 175 bp
possibly a problem with the relay all along , i changed the start capacitor as the comp. was not kicking in , i’m not sure which of the alterations i made fixed it but its working fine !
Re: hotpoint rf 175 bp
went back to this armed with some resin and a start capacitor , fitted a new capacitor and glued the relay housing back together , i put everything back on the side of the compressor and hey presto comp. fired up and is pressurising the system all is well in the sunny s.e.
Re: indesit w123 uk bg
i contacted customer and advised on cost of repair and she is going to buy a new appliance as it is 6 yrs old,
thanks to all who gave inputRe: indesit w123 uk bg
they’re both energised , the wires are heading back down the r/h front past the door interlock, i see the control board down there near the base !
Re: hotpoint rf 175 bp
i checked system electrics from live and neutral on the plug to the relay and the o/l protection on the compressor all seemed ok there is nothing in the freezer so i checked the compressor and it was warm not very ,but not cold either , i checked the start capacitor also but when i was prising off the terminals connected to the relay it broke the relay in half , it was a perfect break though so i think some resin will stick it back together anyways is there a thermistor or thermostat in the freezer section of these that would cause a low temp fault to the freezer coil thanks
Re: tricity bendix aw1201 not taking water
that worked alright , amazing what a little moisture and carbon dust can do to an electrical system !!cheers one and all
Re: tricity bendix aw1201 not taking water
do you mean connect .net the group which distribute electrupart and avix spares ? , do you need to register with them as an independant?
Re: bosch KAN58A40GB/07 freezer not freezing
i ordered the evap fan motor 10 days ago , just got it yesterday fitted and working well now thanks guys
