Forum Replies Created
-
Posts
-
Re: Indesit Test Tool
the plug on the bottom corner on its own with a 2 terminal connection, from mains filter j1 connection.
Re: Zanussi ZBM799X Aluminium Panel, replace or not!
iv had this before, i think it must be to deflect the heat upwards away from the base
Re: Zanussi ZWF1421W drum stuck
theres a sock in it, as your little feathered flightless friend said time to go fishing 😉
Re: Indesit Test Tool
i have 1 and use it a lot, plus baron when programming a smartcard pcb if you just connect live and neutral on corner works everytime .
Re: Hoover VHD9143ZD 80 NOT WASHING OR SPINNING
check pcb for blown triacs, if its a new board will prob need programing .
Re: freezer is cold but not freezing cold
🙁 sorry but my crystal ball isnt working to well today 😆 ,give us half a chance, make, model number , where is it situated ? and you might get a more specific answer.
Re: Hooverman
its a wind up gotta be, clearly he doesnt know too much about them as he would have said the brushroll is knackered, as far as im aware it comes complete.
Re: Hotpoint fridge freezer FF187E
are the front lights still flashing ? on these machines you need to reset pcb by turning both fridge and freezer knobs at same time to off wait a few secs then turn them both on.
Re: Hotpoint WF 860, strange problem
on/off button and cancel buttons sticking give same problems, have had the microswitches ripped off by heavy handed customers pushing button too hard.
Re: Proline DWI 5212P
just to get back on track a bit, you said that the spray arm was clonking, the 1st thing i would be checking is tall plates or pans hitting spray arm or most common now is them hanging fragrances obstructing top arm.
