Forum Replies Created
-
Posts
-
Re: bosch d/w sms53e12gb/01 (about 4 years old)
yep, that’s how I do it , mind you I’m suffering with sciatica at the mo ‘ so every job is taking a good bit longer than usual.
The freestanding is the same.Re: bosch d/w sms53e12gb/01 (about 4 years old)
eastlmark wrote:Why scrap? have you seen how cheap the pump is for those? (£62 from qualtex) and it includes the heater, formerly £90 odd in itself on previous Bosch dishwashers. Easy change too once you get the hang of it.
easy to change! how long does it take then- total strip down job innit’, 2-2 1/2 hours ?
if there’s an easy way I wish I knew!
Clive.Re: Hotpoint dryer belt fitting tool
boselecta wrote:I now take the rear fan and the rear motor bolts off to tension the motor in position. (apparently this is the way the Indesit engineers are advised to do it).
will try that next time, cheers for the tips all,
glad its not just me! 😉Clive
Re: Hotpoint dryer belt fitting tool
Ok Jem, will try the qualtex version, any tips on fitting the condenser belts or is it a case of
blood sweat & tears.Re: Hoover WMH139D/1-80
Bu**er, forgot to check that, as code indicated draining fault, Thanks Martin for reminding me i’m going senile!!!!!
Is it worth going back to check , d’you think?Re: Genuine part numbers CONNECT
boselecta wrote:I stopped using them about five years ago for this reason. The strange thing is that you guys seem to have just been barred from the genuine part numbers now.
A few years ago I used Qualtex, Masterpart and Connect in about the same proportions. Now with Connect hiding there part numbers and Masterpart having nothing in stock its virtually all Qualtex for me. 🙁
ditto
Re: Hoover washer ASM160UK S/N.31000584 Door lock proble
Thanks Martin,
“Hoover” – bleedin’ cost cutting cheapskates.
Have found the Bosch locks (look similar) tabs will snap off – if you’re not careful.Clive.
