[suedehead1]

Re: samsung soap dispenser

thanks very much.

[suedehead1]

Re: Hoover HDV6 Tumble Dryer power switch broke

the switch isnt supposed to stay in it only energises the relay on the small pcb behind the control panel, the pcb will need replaced.
plug out obviously.

[suedehead1]

Re: samsung soap dispenser

anybody got access to samsung website?

[suedehead1]

Re: Servis symbols

from the left prewash, large load, no spin.

[suedehead1]

Re: triton shower

finally got tthe shower fixed the part came in a few days ago and i got round to changing it today and its working fine.

[suedehead1]

Re: I have a Servis 1600 model M6006

the part number on the old board should be the same as the part number on the replacement board,

[suedehead1]

Re: hoover wdm120

did you check for a hole in the tubing?

[suedehead1]

Re: indesit wil133

the start button was stuck in a spray of wd40 and its sorted.

[suedehead1]

Re: triton shower

both halfs of the heater check out ok there is a pcb with a couple of relays on it and the contacts look a wee bit burnt so i dont know know what to do.
i watched the 2 relays while testing it and only one energises so it needs a new pcb thanks for the help i will order one and give it a try.

[suedehead1]

Re: triton shower

thanks for he reply it only says opal on it are parts readily available for it,
i think you are right with the half heat it doesnt seem to matter wether i have it on full heat or half heat it is still the same temperature it looks like i will need to get the meter out and check it
thanks for the replies guys.

[suedehead1]

Re: Hoover Condenser Tumble Dryer

it could be the relay but it might be the capacitor.

[suedehead1]

Re: servis m6011 washer keeps taking on water and draining i

it sounds like the pcb is faulty plug out if checking.
but there will probably be nothing visible.

[suedehead1]

Re: indesit wil133

yes i thought so too thats why i changed the main pcb but it didnt fix it.

[suedehead1]

Re: Hoover HF7 130M Rinse/Spin Problem

suedehead1 wrote:if it stops before the rinse cycle it could be a water valve problem, a pressure switch or pressue switch tube blocked, or the pcb.

all of the above can cause intermitent faults, solenoid valves can go open circuit when hot and be ok when they cool down pressure switches can do the same a blockage in the pressure switch tube or bell will normally allow machine to fill then empty but not be able to tell the pcb that there is no water in it so it wont fill up again.
pcb has many component which will give an intermitent fault.
thats the problem with intermitent faults.

[suedehead1]

Re: Hoover HF7 130M Rinse/Spin Problem

if it stops before the rinse cycle it could be a water valve problem, a pressure switch or pressue switch tube blocked, or the pcb.

[Author]

Posts