Forum Replies Created
-
Posts
-
Re: hotpoint wma11
I used to WD-40 the Comm, clean it up, wait for dry then change brushes.
Slow but works 😥
Re: WMA bearing change
johnnyj wrote:Fastest full tub i have done was 27 mins in a garage could let everything flow, usualy about 35 to 40 when i’m dawdling, back half and spider usualy about 50 to 55 mins, washer dryer usualy about 80 mins. I’m still a Hotpoint eng for my sins.
did you press start on E-MIT after youd done the job?:rotl:
Re: New Breed of Twin Tubs
Dave_Conway wrote:The Norfrost one is an utter pile of cak in my opinion 😉
Not seen the Qualtex one although it looks a bit “plastic” to me from the picture.
What others have you seen ?
Dave.
Is that the one called “Velo” by any chance? big steaming pile of doo-doo.
not well built.Re: WMA bearing change
29 Minutes to fit a 1603410 Drum for WMA
4 Hours to fit a 1602321 Drum for WD
50 Minutes to fit a 1603100 Drum for WMI Was doing 2 WMA Drums a day, though….
ANd don’t Laugh at my time for the washerdryer. 😥Re: Filter Blocked error on Hotpoint FDW60G 1 – But it is no
At a guess, have you checked how low the waste-hose is down the standpipe? or is it connected directly to the sink waste? as a former hotpont engineer, was a common problem (im assuming its a new appliance) but i have not worked on this model.
Regards.
P.s. Power off (plug out of mains socket) before ANY checks please.. :zap:Re: NO display WMA63S
Yes you can.
Its quite a farce though. i cannot remember, (i’m a former hotpoint engineer) edit: just realised iadom’s post.
if its the Wammy 63S im thinking of, with the digi-display, they knacker quite often.
it Cant be the door lock if the door lock is energised and voltage registering thru…
order both boards….
Regards.
Re: Funny pictures… (beware: cookie assault)
im sorry in advance but you can delete this picture of me and the groupie if it causes offence.
http://www.myjokemail.com/content/uploa … s/3286.jpg
http://www.myjokemail.com/content/uploa … os/301.jpg
http://www.myjokemail.com/content/uploa … os/320.jpg
one for r600a
Re: Armageddon is coming
neptune wrote:If its gonna be that bad , armageddon outa here !
🙄 :martin:
Re: WMA bearing change
i just press the lug with my one hand and pull with pliers with the other hand.
