[tinfish]

Re: Haier HW50-1002W cutting out

Thanks, that would explain it.

Grant

[tinfish]

Re: Maytag MWA09149WH showing F22 error

Thanks, but I’m pretty sure it’s a 3 phase motor. It could still be a motor fault causing it, as it definitely isn’t going round…

[tinfish]

Re: Zanussi ZDF 14001SA fill problems.

thanks

Grant

[tinfish]

Re: Beko WMB 91442LW – shows 14 minutes, won’t start

Yes it’s the new style motor. Had trouble with one of them before.

Thanks

[tinfish]

Re: Samsung WF431ABP DE1 error

Thanks, not what I was hoping to hear, but it would have been my guess. Looks like I have a £50 interlock that will be living ion the van for the foreseeable future as I doubt she’ll stump up for a PCB..

Grant

[tinfish]

Re: Panasonic NA147VB2 washing machine

This one is a bit of a pain. When you open the door there’s a trim panel that you have to remove that partially holds the front on. There’s screws behind the fascia in the middle and a couple at the bottom. The retaining springs for the door seal are a bit different as well.

Grant

[tinfish]

Re: Older NEFF oven maybe not heating properly

Thanks for that.

I should have said the hinges and seal are fine despite being 15 years old.

I’ll try what you said.

Grant

[tinfish]

Re: Miele G579SC

Thanks, I’ll give that a try.

[tinfish]

Re: Hotpoint Aqualtis stopping and lights flashing

She got Hotpooint in, it needed a PCB, heater, NTC and something else she couldn’t remember. It’s only 18 months old.

[tinfish]

Re: Hotpoint Aqualtis stopping and lights flashing

The machine is under the stairs in a very narrow extension, so no I didn’t check the heater, I was trying to get it to repeat the fault. It was something I considered, but it ran through other programs without stopping. I’ve since discovered it will run through these programs empty, but when full of washing it stops at 25 minutes. She emailed me a video and it’s the program lights and the on/off light flashing at 100mph.
Drain is fine, it’s into a standing pipe at the back that’s almost the height of the machine.

[tinfish]

Re: Thermostat for an Ikea Oven

I’m positive, number’s on the oven, the receipt and the books. I bought the NTC before opening the thing up – so I’m out of pocket for that before I start.

[tinfish]

Re: Door for Zanussi ZUD 9154 integrated fridge

It is 923734650, but after our chat today I’m not too hopeful.

Grant

[tinfish]

Re: Beko ODF22300x – heating when it shouldn’t

Whole thing was pretty low insulation.

When it started arcing across a gap in the blown element and heating up while switched to light (with the wires to the light disconnected) I decided to call it a day. It had also managed to cut through the middle of my fingernail and there was blood everywhere…

Skip time.

Grant

[tinfish]

Re: Beko ODF22300x – heating when it shouldn’t

Thanks.

Apparently it’s been working perfectly until recently. Can’t understand how it’s possible for power to get to the element when it’s turned to light.

Grant

[tinfish]

Re: Zanussi ZWG7160P drum paddles

Thanks for that, would never have thought to look under the counterweight.

Grant

[Author]

Posts