Forum Replies Created
-
Posts
-
Re: Qualtex Account Closure
Had the same letter – Apparently it was supposed to be shutting down DIRECT DELIVERY account only i.e. orders delivered direct to my customers. My trade account is still good.
Might be worth double checking? We use H.T Maddocks a lot to be honest and although the stock holding isn’t as good the prices on some parts are unbelievably better. I’m pretty confident they don’t have a retail site either.
Re: reset procedure
Thanks Martin!!
Did that (Rotated dial to position 15 pressed and held start button for three seconds and then turned it back to position number 3 which tests the motor).
Another Bosch engineer helped me out but thought I would post reply to say thank you and in case someone else gets the problem on a Bosch that has no ‘spin’ option button 🙂
Re: AEG washer Dryer – no heat on dry
Tried that Martin – but thanks!! Went back on Saturday with a new dryer board and all ok now :-)))
Re: AEG FAVORIT24502VIO Half Full
Sounds like it’s taking too much water rather than not enough! Does the drain pump not run when you reset?
Re: Ceramic hob cut out size
http://www.montpellier-appliances.com/p … amic-hobs/
This one should fit without the clips 😉
Re: Bosch D/W ‘check water’
I had a faulty impellor jug that cured the fault for a few washes but then went back to error. Checked everything else and fitted new jug out of desperation …. It’s been fine for 7 months 😉
Re: Miele W5780
Sorry for the delay Dave and thanks for your response. I’m getting 240v on the end of the flex and 240 coming out of the mains filter.
Re: Brittania ceramic range – top off?
Thanks Swerv….Tried that, but the top just wont push forward. It’s a real odd one because it looks like the top can’t lift off because the bars that hold the plate elements in place are wider than the top (They go under the lip of the side panels) if that makes sense?
I managed to renew the ‘stat after taking the back panels off, but now it needs a new clock too and that will be a pain in the butt if I cant get the top off.
Any other suggestions anyone? PLEASE
Re: BSCH CTD WTW86561GB/02 Cutting out after 5 mins
Okay so here’s an update….It’s a heat pump dryer by the way.
Any programme that is selected, starts and runs for less than 1 minute before the display goes completely blank and the drum ceases to rotate. At this point there is still a 240v feed into and out of the mains suppressor.
It then takes around the same time (around 30 – 45 seconds) disconnected from mains supply before the display returns.
ANY IDEAS ANYONE????
:-))))
Re: Whirlpool ADG7790 (851177915810) F2 error
Diaphragm switch Grendal? Is that the hydrostat switch 481227128557 also listed as optical water indicator on connect.
Customer has been on holiday so has now just come back to me !!!
