[Washman]

Re: Hotpoint EW74X oven not working

Hi

How are you checking ? Are you using a multimeter or one of those electrical screw drivers. The only way is to use a multimeter to check the wiring.With power off.

Washman

[Washman]

Re: Siemens WXLM148AGB/19

Hi

After six years the brushes will need changing, worn brushes give off an arcing sound. Do not use machine until you have checked brushes,arcing brushes can blow main boards.

Washman

[Washman]

Re: Hotpoint WDL540 4 light error code

Hi

iadom has already answered you query.
Check all the parts of the dryer.
The machine is made by Indesit as iadom says so the electronics can show up weird codes unrelated to the actual fault.

[Washman]

Re: Broken EOB976 oven

Hi

Have you checked that the clock is set to manual and not auto,it has to be set to manual to work.

Washman

[Washman]

Re: Hotpoint WD240 Washer/Dryer machine

Hi

Lights 2,3,4 = F07 = Heater relay fault.

Washman

[Washman]

Re: Hotpoint VTD00

Hi

Have sent you service manual PDF

Mike

[Washman]

Re: AZB8680 whirlpool dryer

Hi

F 07 =Drum sensor failure
Potential causes
Drum sensor defective
Magnet not in correct position or missing
Electrical connection between reed switch and control board
Drum doesn’t turn

Carry out reset . To carry out reset ,must be performed in 10 sec
a)turn selector to 6 oclock pos
b)Push start button 3 times
C)turn selector clockwise one position (airing prog)
D push start button 3 times

Mike

[Washman]

Re: Neff D/W 5943X2GB/31 Module Blown

HI

You will need to check the connection and wiring from that part of the board ,back to the component it is connected to.

Mike

[Washman]

Re: Whirlpool oven AKP207/1X flashing – – – C

Hi

Have you checked to see if it has a child lock setting on the controls.

Mike

[Washman]

Re: Bosch WVT1260GB fills with water on drying cycle

Hi

The water condenses the steam and has to flow all the time . If you stopped the water flow it would not dry.
You need to clean the condenser and make sure the drainage system is clear.

Washman

[Washman]

Re: Diplomat Oven not heating over 120C

Hi

Have you fitted the thermostat sensor in the correct position.

Washman

[Washman]

Re: WMD960 – F01 etc

Hi

New PCB is not programed, so a card reader and smart card required.

PCB About £115.00
Smart card About £20.00 (use once only)
Card reader About £116.00

Washman

[Washman]

Re: Is there money to be made in selling 2nd hand parts

Hi

You also need all the correct paperwork for handling/ transporting waste and hazardist waste materials.

Washman

[Washman]

Re: H/Point VTD00 T/Drier – vibration after drum shaft kit f

Hi

Put PTFE or silicon spray on the felt ,I do and helps alot.

Mike

[Washman]

Re: Kippersbusch EEB6300.5MX

Hi

Part no for knob from diagram 528358

Mike

[Author]

Posts