[washtronics]

Re: Hotpoint VTD Tumble-dryer – noisey, resonating, vibratio

yes, i have had that on pattern front bearings, i only fit the genuine kit now-it is not much more in price anyway

[washtronics]

Re: Candy F233/3XUK built in oven

if there is no back panel inside the cavity then it is removed from behind the rear panel of the cabinet, it comes out as a sub assembly with the fan and element. Similar to the old ECKO/Philips ovens of the early eighties

[washtronics]

Re: Zanussi DA4342 – Tripping Circuit Breaker??

usually the heating element with an earth fault

[washtronics]

Re: Best Hotpoint Washing Machine

the aqualtis are reasonable quality machines, but still have sealed tanks and fragile electronics, as long as you get an extra warranty on it then go for aqualtis

[washtronics]

Re: Indesit dishwasher puzzle???????????

water may of gone up pressure switch pipe, if you lean it over, always put it on its left side otherwise this can happen

[washtronics]

Re: aeg l16810 w/d door lock fault

I had this fault, changed the interlock and it worked.

[washtronics]

Re: Hotpoint washer dryer WD420 – water pouring out of soap

if you remove the ecoball on a bosch washer drier it causes a f17 fault

[washtronics]

Re: Guarantees for Work providers

I only give 30 days on horseshoe bosch elements. Most other repairs i give 6 months

[washtronics]

Re: Cannon Range Cooker – Oven Not Working

will probably be the oven thermostat-it is a 3 tag combined switch/stat, i have had a few of hotpoint/cannon cookers with this fault

[washtronics]

Re: QER.BIZ

i have got lots of w/m boards from them, they repair the boards that i have sent them. Dont think they do the hot/ind programmable boards though. Quality electronic repairs(QER) seem reasonable prices and fast turn around time.

[washtronics]

Re: Washing Machine Use Without Plumbing

when i test machines in my garage i fill them up with a hosepipe put in the dispenser, i wouldnt recommend this for a whole cycle because it fills and drains quite a few times throughout the cycle and you would have to stand in front of it listening for the humming noise of the inlet valve when it needs water

[washtronics]

Re: AWP510L fill & drain only

the pulley bolts come loose and belt comes off

[washtronics]

Re: Strange noise after replacing drive belt on Creda Revers

i had similar after fitting bkt87 drum repair kit-pattern parts, had to go back and fit original type front bearings

[washtronics]

Re: Indesit WIDL 126

the original modules are different from the new ones supplied. you also need to get a wiring kit from the module to the drier heater, fan and solenoid. Also the module will need programming with a smart card and reader

[washtronics]

Re: Miele T294C Condenser dryer TOC

i reset lots of toc by dropping onto concrete from 2metres height, works every time. make sure you drop it metal side down

[Author]

Posts