whiskeyjack6058

Forum Replies Created

Viewing 15 posts - 91 through 105 (of 250 total)
  • Author
    Posts
  • in reply to: Proline top box little fridge freezer thermostat? #304395
    whiskeyjack6058
    Participant

    Re: Proline top box little fridge freezer thermostat?

    yep, just the one stat and its one of those fridge master/cool zone skanky type things. Not sure of its contact temperature, I seem to recall there are a few different versions of these..

    in reply to: Hotpoint dishwasher foaming up… #303955
    whiskeyjack6058
    Participant

    Re: Hotpoint dishwasher foaming up…

    This guy is VERY used to dishwashers, we agree that detergent seems like the most obvious answer but why should one hotpoint dishwasher opperate ok with one complete tablet in and then this one more or less over foam with only half a tablet in?
    Bit weird if you ask me… I have done loads of d/w repairs myself in the past and present and come accross the over foam problem just about every day. He seems quite sure this isnt the issue here.
    Rinse aid tank is completley empty and salt makes no difference either..
    God knows…
    Thanks,
    Rob.

    in reply to: Electrolux EWX14440W integrated washer dryer wont start. #303566
    whiskeyjack6058
    Participant

    Re: Electrolux EWX14440W integrated washer dryer wont start.

    I didnt have the time to un-build it and drag it all out Mike. Its 20 storys up in a luxury rented appt in the city center of Leeds and the letting agent was house sitting with me while clock watching… Grrrrrrrrr
    I had a better look at it on the TDS disk and it looks like its one of the controll panel PCBs on the disk. The TDS disk also states that the un-configoured pcb is unable to be setup without the relevent software/hardware.. Fantastic, thanks for that electrolux..
    I might just take the risk and order up PCB an interlock.. bit worried about it, but i suppose sometimes you just have to take the plunge… To be honnest, I think I would rather not get involved in this, but the luxury development where this machine sits is part of a few thousand and my good reputation is getting propergated between its various letting agents so I want to be sucessfull. I have suggested I might have to put one of my loan machine’s in place if things become complicated..

    in reply to: Electrolux EWX14440W integrated washer dryer wont start. #303564
    whiskeyjack6058
    Participant

    Re: Electrolux EWX14440W integrated washer dryer wont start.

    is someone delting my posts off here????
    Yes it lights up and looks completley normal until you press the start button…

    in reply to: American Whirlpool fridge Fridge freezer ‘CF’ Error. #302677
    whiskeyjack6058
    Participant

    Re: American Whirlpool fridge Fridge freezer ‘CF’ Error.

    That’s very helpfull, thanks very much Chay..

    Kind regards,
    Rob.

    in reply to: desperate for help #300558
    whiskeyjack6058
    Participant

    Re: desperate for help

    Think I’d start looking for broken wires… Perhaps in the door loom…

    in reply to: bosch w dryer. #300850
    whiskeyjack6058
    Participant

    Re: bosch w dryer.

    Pump open circuit? I know on some of the older machines this could cause a no fill fault also..

    in reply to: WhiteKnight tumble dryer drum bearing assembly required. #298946
    whiskeyjack6058
    Participant

    Re: WhiteKnight tumble dryer drum bearing assembly required.

    Well I suppose if anyone would know it would be you Chris. I had a feeling it would be. Uneconomical to repair… What a waste!
    Thanks for your help though!!
    Regards
    Rob.

    in reply to: Emergency services Limited??? #296363
    whiskeyjack6058
    Participant

    Re: Emergency services Limited???

    Yes, thats them.. going to put my bill in, will let you know how it goes..

    in reply to: Bosch SGV53EO3GB/50 #292880
    whiskeyjack6058
    Participant

    Re: Bosch SGV53EO3GB/50

    I would send the module in to QER and get them to test it. It doesnt cost much and could save you money in the long run..
    regards,
    Rob.

    whiskeyjack6058
    Participant

    Re: 2 x Hotpoint FDW60P Dishwashers throwing the same fault

    Correction, its LED 4 & LED 6 that flash..

    in reply to: Attention CDA Agents………….. #282481
    whiskeyjack6058
    Participant

    Re: Attention CDA Agents…………..

    This feedback makes me feel better, I have been racking my brain to think of a job thats gone wrong without me knowing and them not saying (although I think they would have).
    Well, at least Im not the only on in the boat. Just praying it comes back.

    in reply to: Hoover HND235-80 dishwasher PCB Required. #281929
    whiskeyjack6058
    Participant

    Re: Hoover HND235-80 dishwasher PCB Required.

    Perhaps I had better check out my model number again…

    in reply to: AEG L14500VI Main module required #281288
    whiskeyjack6058
    Participant

    Re: AEG L14500VI Main module required

    Thank you very much…. 🙂
    Regards,
    Rob.

    in reply to: AEG L14500VI Main module required #281286
    whiskeyjack6058
    Participant

    Re: AEG L14500VI Main module required

    Well learch, she wants it doing so I better get my act together and look into the configouration process I suppose. Any pointers into the right direction would be very much appriciated!!!!!
    Thanks,
    Rob.

Viewing 15 posts - 91 through 105 (of 250 total)