Forum Replies Created
-
Posts
-
Re: FDW20 Heater Change
have changed hundereds of these and I use a terminal screwdriver to slacken the clip off by inserting driver in raised part of clip and twisting slightly to releave tension on clip . remove heater , insert new heater and retighten clip with either sidecuts or endcut pliers.
Re: wma bolts
hi , had a count up and have 350 of them , electrue advertise at £24 + vat for 30 , if u want 100 i can do them for £25 + vat , if you want 350 make me an offer
Re: hotpoint fdw 65
I know you say its heating fine , but remove heater and look inside , if it is scaled up that is the problem , the elements overheat and the cutout trips , once cooled down they work again . I have had sucess just running a descaler through machine but prefer to change heater and tell customer to do regular descales , Hope this helps
Re: Indesit WD12uk
apparently according to indesit technical it is caused by the customer using excessive detergent and foam being forced through the dryer box vent during spin.
Re: Ariston AWD12suk grommet
they are held on with a wire type jublee clip which is part of the sub kit supplied with replacement tank , dont think there listed seperate. although sub kit should be but it contains 2 blanking plugs , clip and door seal and retainer spring .If you get stuck let me know as i have plenty of them kicking around van.
Re: Indesit WIDL 126 UK
does the light flash with the program selector knob in the off position . if so this is quiet common and requires the module replacing . have been to many of these with that fault , reprogramed eeprom and still the same so the only cure is the module im afraid
Re: Indesit wiring harness part number?
this should be a 12 way connector to J8 on module ,valves and wash thermistor. Part Number from what i can suss is C00109950 for hot and cold fill machine , and C00140536 for hot fill only machines (a whopping £100 + retail on this one 😯 )
Re: Ariston Oven Door glass – 208588012
the model number for this is a dov317/1/wh , you have the Stoves number . Main oven door glass outer is pt no C00157007.
Re: how to reprogram hotpoint wma 10 control board
With selector in off position press and hold rinse hold and energy save buttons whilst selecting k program and continue to hold until lights flash (5 secs) , now press start button til all lights go out . now select M press start , P press start , A press start twice , job done
Re: Ariston Dishwasher
Check the heater is not short circuit. This can cause all kind of bogus error codes.
