Forum Replies Created
-
Posts
-
Re: Finally….
I’ll look out for it next time the TV programs take a tour around Jamie’s house 🙂
George
Re: Diplomat ADP8342
Hi Mike… This is one os the old MFI machines so yes, proberbly Servis, but can’t guarantee that…
Customer say that when she opens the door it is steaming hot, a woft of steam rushes out of the door.. (Maybe thermister is not sensing temp) …
Can’t see it being a syphoning problem as it would have never worked properly in the first instance….
Didn’t think it would be the timer as it is electronic (so I believe) and for all other programs to work except one is not the norm in this case….Service manual would be grat at this point 🙂
Nice to hear from you Mike… Hope you are well 🙂
GeorgeRe: INDESIT IS60V OVERHEATING
I believe the temps for the orange set are 120 degs and 150 degs
George
Re: 104 stolen washing machines
Will do Phil.. most likely they have headed for Liverpool or Skem, but I’ll keep a watch over here.
George
Re: hoover h160e pcb repair – which pump triac – is this ok?
leavemetogetonwithit wrote:My God, things must be tough going up there, wherever you guys are!
MAC97 Qty 1 @ 46p + vat including g’teed next day delivery.
Mike.That’s a Mac97A8G Mike… Different monster so I am informed (by RS & Farnells)
George
Re: ASKO bearing change W6461
kwatt wrote:Not that difficult, but you do really need an alignment tool to do it. It can be done without on, Andy at APG has done it, but I think anyone that knows the machine will tell you that it does make life a lot easier.
The ISE10 video shows it in detail. Dunno if you have access to that as it’s on the DVD.
The alignment tool we are waiting on but I know a few people do have them.
K.
Are the same tools required for the W6561 ( alignment tool & Bearing tool)?
If so, where can I purchase/get them and at what cost?
George
Re: 0800 Repair
Martin wrote:But all the while you must realise that DASA encompasses all within its midst and all therefore can contribute as all are directly involved in domestic appliance servicing after all said and done.
Yes Martin.. even the manufactuers that build the appliances so that they can not be serviced.
George
Re: hoover h160e pcb repair – which pump triac – is this ok?
not sure… Mac97a8 is the important part.
George
Re: hoover h160e pcb repair – which pump triac – is this ok?
Before you try it.. download the datasheet for the triac mac97a8 you have and the one you are going to try replace it with so that you can see the operation of each… These mac triacs are Logic level Sensitive Gate triacs. I wouldn’t want you to trial the wrong chip and destroy your board.
