[bassman]

Re: Miele G646SC dishwasher

I have had similar problems and found the overfill float switch in the base corroded clean or replace microswitch and all should be ok

[bassman]

Re: Beko WMA 510 Auto

I checked for syphoning but not sure if this machine has a rinse hold button I will have to check.
Thanks for the replys.

[bassman]

Re: Beko WMA 510 Auto

Yes Heater is Ok Thanks

[bassman]

Re: Configuring Zan board!

I,m sure I have done this in the past if I remenber right try using L0 instead of L10

[bassman]

Re: Beko Washer WM1010

Thanks for your replys everyone much appreciated

[bassman]

Re: Beko Washer WM1010

Thanks for reply Micky32 but I’ve allready told him to check that.
Can anyone tell me if this machine has a module.

[bassman]

Re: Fault Code Guide

I have just received a copy of the fault code guide and I must congratulate you on a very usefull guide, allthough I am now retired through ill heath and for those that know me I am on one of the new cancer superdrugs and so far a scan has showed that my tumors are shrinking great news for me, I still do the odd job for friends and family
and still keep an eye on the goings on at UKW so I orderd a copy of the fault code guide and I must say what a gret job you have done, it must have taken a lot of work to edit all that info into the guide.
I hope everyone realises what a great organisation we now have in UKW,
Thanks to all who help run it ,keep up the good work.
Ray Biddle

[bassman]

Re: Who Makes Matsui Dishwasher

I was thinking that myself but didn’t want to say it in case I was wrong

[bassman]

Re: Tecnik Dishwasher SE6TIE1GB/12

Thanks for the replies I,ll check the mains first and post again when I,ve had a look at it

[bassman]

Re: sharp R-95STM

This is a sensor fault but I cant remember which one if I can find my manuals I will let you know but I haven’t used them for such a long time I cant remember where I have put them.

[bassman]

Re: contract work £22000 turnover goodwill for sale

Thanks Ken I have only had one reply but no follow up if anyone is interested I only want £2000 Im open to offers this is really a good little earner and I need to do something this week as I cannot service the accounts any longer and I need to start claiming incapacity benefit so I will just have to let them go.

[bassman]

Re: Miele T5206 Dryer

Thanks for replys I am going to try a new contactor.
When I was talking about water running through filter I meant the fluff filter it can look ok but to test if it is clear you take it out put under tap and see if water flows through it if it doesn’t the filter is blocked by grease and needs cleaning.

[bassman]

Re: Whirpool AWG349/3 wont start

Thanks guys I forgot to mention I had checked pump But I did not check at PCB connectors or the motor.
Thanks again BassmAN

[bassman]

Re: Hotpoint WF440

Thanks Steve I am going today I will give that a try.

[bassman]

Re: Any good software for Jobs

Dont knock Servis Base unless youve seen it in action its difficult to descibe how good it is you need to see it work its super fast on searches you can just input a postcode to log calls alltough that does cost extra but if youre doing good business it will pay fir itself in no time . If your ever in my neck of the woods (brum) come and have a look.
I have read a lot on this site about looking for good software its allready available and has been for years.

[Author]

Posts