[bazza500]

Re: Beko WM95135LB problem

This fault is usually caused by the motor if it has the weird looking brushless one fitted.

[bazza500]

Re: Main oven door Beko BDVC664K

I got my part number off the Beko Tech site

[bazza500]

Re: Main oven door Beko BDVC664K

I get 210301131 but can’t see if that comes with inner glass.

[bazza500]

Re: Christmas 2015

Anywhere as long as it has a bar

[bazza500]

Re: Zanussi aquacycle 1100

Is it flashing red and green. If so yo need to count the number of red flashes followed by the green and post the result.

[bazza500]

Re: pump noisy

New pump required. There is no fixing it.

[bazza500]

Re: Zanussi ZDF14001ka 20 in display

It’s an I20 fault – failure to drain in allotted time.

If it is draining then it probably requires the pressure switch modification to be carried out.

[bazza500]

Re: What are these

they are part of the transit bolts and usually fall inside when the bolts are removed. Throw them in the bin.

[bazza500]

Re: aeg f55002v10p/911436014/02

Make sure the air trap is clean, there is no water in the pressure hose and that the mesh filter is spotless.

[bazza500]

Re: Zanussi condenser dryer not working on normal load

Sounds like the motor start capacitor is goosed

[bazza500]

Re: Zanussi error code 15-2?????

Fault code is EF2. Overdosing with suds. Give it a good run through at high temp with nothing in it Jim and that should sort it, or strip the pressure system to clear.

[bazza500]

Re: zanussi dishwasher esl6115

Two pressure switches fitted to the right hand side of appliance but can’t find one in the sump.

[bazza500]

Re: IKEA Zanussi dishwasher

It requires the pressure switch modification

[bazza500]

Re: JLWM1203 Electrolux tripping RCD

You need to do an insulation test on the heater to check for an earth leak

[bazza500]

Re: Mobile Payments

It’s a bit chicken and egg stuff, but if the rate was right then I’d be interested.

[Author]

Posts