Forum Replies Created
-
Posts
-
Re: Beko WMB81445w
You don’t get reading through any of the connections on these motors even if they are ok.
Re: Zanussi ZWH 6120P, flashing start button
Count the flashes before the pause. It should flash red so many times and then green.
Re: AEG L61271WDBI Washer Dryer Unresponsive
Check the dryer element for an earth fault as this will give symptoms of a dead machine on this appliance.
Re: AEG Favorit 55002 dishwasher drain fault
You need to clean the air trap. If you remove the front lower panel and look for where the pressure switch pipe connects to the sump. Then put a torch inside the dishwasher shining towards this and look from the outside. You will see all the gunk inside. The best way to clean this is to remove the hose and flush water into the sump with a bit of pressure then remove the dirt from the inside. Power off first.
Re: The Noise
Surely if they work the same as most other companies then April invoices will only be due yesterday , the end of the month following the month of invoice.
Re: Zanussi ZDF 14001SA fill problems.
You’re correct it will fail, but it would have cured the fault until it failed in a few months.
Re: Leisure Rangemaster 110 All 4 hotplates
It would seem that it is 2 off P025630 and 2 off P025631
Re: Zanussi ZDF 14001SA fill problems.
Yes , but if he’s already tried another pressure sensor and it hasn’t cured it then the mod isn’t going to cure the fault.
Re: Rangemaster Induction E4 error code
May be a longshot but I had a fault like this a few years back. It turned out to be the white plug at the rear of the hob. The one you would disconnect to remove the hob. The pins were pushing out of the plastic plug when the male and female parts were pushed together. This gave me E4 on 3 rings and took a while to find it.
