Forum Replies Created
-
Posts
-
Re: gw709 motor controller board replacement
Water Valves can have intermittent problems (Check there is is no Cracks on coil) Would also check the Pump & if There any signs of leaks from Main Shaft(Water Can leak onto RPS sensor & motor windings ) We generally check the motor windings as a matter of course
Re: Aquasmart WL70T60 diagnostic mode entry? + Balance probl
Seem to recall having same problem with same model (under warranty)about 18 months ago .FP Advised us to change bowl ,suspension & Motor control module Improved to some degree but in the end they ended up changing Machine over. Never did find out what the problem was from F&P .
Have not thankfully had one sinceRe: Motor controller module info for GW709
Short ANSWER NO
We as repairers replace the module complete Although electronic experts have repaired them successfully
Be sure to check the quality of the inlet coils(64ohm) & check for cracks in the casingRe: dammed public
Its the same scenrio this side of the world
W e do 50-60 Service calls per day
The bottom line is you have to spell out your service call rates
Our service calls vary on the distance we have to travel(on avg $66-00Au)Our service call includes the first 15 mins only /then we charge at an houly rate ($88/HOUR)
Yes we can estimate over the phone on what the repairs may cost
Certain machines do have there inherent problems
No way do we give frre quotes
What is the point
Spell out why there is a servive call fee/ Vehicle Costs ,Insurance,Phone,Training,Super,Expertise,Etc Etc
Sure we get caught out as well
But the bottom line spell out the terms to start with & you will weed out the crapRe: FISHER & PAYKEL Intutive IW811 Service Manual wanted
More cases than not likely Motor controller Fault (Main Module)
In some instances can be RPS(rotor postion sensor)This is the smaal PCB Clipped Into MotorRe: fisher paykel has no power
The Pump in this Model forms part of the power circuit
It may well be the pump If not it will be The Main PCB (Motor Controller)Re: Fisher and Paykel Smartdrive 703
The only way you are going to get out of it is by replacing water valves
Re: Fisher and Paykel Smartdrive 703
No resets on these for valves (only for water temp)
Have you checked the inlet hose filters? (NOT BLOCKED )Re: Fisher and Paykel Smartdrive 703
Nothing youve done there
Common fault with the inlet Valves The internal diaphrams in the valve dont open fully to allow a better flow rate
The Valves are complete Assy with coil
Part # 426143 Cold Part # 426142 HotRe: LG WM1480 FHD washing machine showing ‘DE’
Down this way
OE- Outlet/Drain error
dE-Door Error Lid error for top loaders
LE-Motor Error
Same error code for all LG Front Loaders &Top loadersRe: Simpson 5.5 always out of balance
Theres no no transit bolts as such only strapping under washer to keep bowl in place /There hasnt been any issues with OOB problems I would contact retailer to organize something under Warranty
Re: How to replace F&P GW711 motor controller board?
Size Setting has to be Set
Power on at Wall Power off At Machine
Press&Hold TEmp up & Power
Press spin speed up until spin hold LED is lit
Press power to confirm setting
