Forum Replies Created
-
Posts
-
Re: Stoves ES600 MK2
hi JJ
have a look here http://www.gdhaonline.co.uk/default.aspx if the parts not listed give GDHA a call.
Bob.
Re: Ariston A1636 Pulls 8amps but only for 5 minutes?…
heater should be 30 ohms – thermister should be 20k at 20c.
worth a shot at the thermistor first but it may be the pcb.bob
Re: Candy oven IF20 39500004
old part number is 02327039 new part number is 92023274, check with your supplier as it is still a valid gias part.
bob.
Re: Hotpoint FDW80 dead
check the motor and heater for earth leakage as it locks out the 100bit module also check for sticky console buttons as this also locks out the module.
Bob
Re: Indesit DI450
lights 3 + 5 is a heater related fault, check heater, wiring or the pressure switch.
Bob.
I have emailed you the service manual.Re: Hotpoint BCi45C wiring loom
can not see model BCI45C but there is a BCI45 and the loom part no is C00093684, com code for correct id would be helpfull.
Bob.
Re: Customer gets discount from Hotpoint spares.
the oven lamp is supplied by the main pcb, if that needs replacing make sure the eeprom is also ordered as the pcb is blank and is not programed via the smartcard or laptop as per normal.
Bob.
Re: Hotpoint DWD129
on all versions of the UY46K and there is 3, the switch disconnects the neutral supply to the fan motor and element.
Bob.
Re: How do I change the door seal on a Hoover Optima
the seal can be fitted it just needs to be prised open a little on the liner to get it to fit, its fiddly but it willl fit, hoover have a tool to do it but its not realy needed.
Bob.
Re: Hotpoint WT761 3 phase motor
what type of motor and software version are fitted to your appliance
Bob.
