[clivejameson]

Re: Scandinova FF6-6845 Fridge/freezer -freezer complete def

There could be many reasons for the freezer to defrost ranging from loose connections to a faulty compressor.

Unless you are of an electrical engineering mind then its best to call an engineer.

You could try Repairs@ to see if there is someone local to you.

[clivejameson]

Re: White westinghouse

Hi Merv

Could be either 5308009754 at 19 1/4 ins long or 5303001362 at 20 1/4 ins long.

Hope that helps

[clivejameson]

Re: Weller pyropen soldering iron

Thanks Dave, unfortunately they only seem to do the ‘consumable’ bits (hundreds of different tips). The part I need is the injector thingy which they don’t list.
might try giving them a ring but i’m not hopeful 🙁

[clivejameson]

Re: Hoover ACM 15 won’t spin

Anonymous wrote:
Have only seen motor turn in one direction? thought that chip on card getting mixed up info from tacho may explain that.

Therein may just lie the problem….if it does only turn in one direction then one of the reversing switches is faulty. I don’t recognise the model but these are built into the timer if it has an analogue control so a new timer would be required.

Not a common fault but one I’ve seen a few times over the years on various makes.

[clivejameson]

Re: Black marks on laundry

Hi Melissa

The black marks are caused by oil leaking from the drum bearings….bad enough but inevitably it means water will have penetrated the bearings which points to drum bearing failure i’m afraid (hence the noisy spin)….I would recommend you stop using it until an engineer has had a look as more damage could be done (thus increasing the repair cost)

Have a look in Repairs@ to see if you have an engineer near you.

[clivejameson]

Re: Bosch SMS4042 water failure

Sounds very much like a water supply problem…have you done the usual checks i.e. fill hose not kinked, tap fully on (gate valves…the type with a small plastic lever are notorious for sticking and the plastic lever cracking)?

[clivejameson]

Re: New Buttons

kwatt wrote:Comments if there are any?

K.

Just a suggestion for a small tweak…the bold titles next to the buttons could be made to link to the section also, as the buttons themselves are fairly small?

[clivejameson]

Re: Mira Sport 10.8KW Shower

Have you tried Parts Center (wolseley)?

[clivejameson]

Re: Poll

how about extended guarrantees/insurances, are they worth it?

[clivejameson]

Re: The customer that insists there is something wrong.

Penguin45 wrote:Go onto a forum. Then go into Profile, it should up load from there, providing it’s not too big.

Cheers,
Chris.

….and if it is try this…….

http://www.jql.co.uk/avatarsizer.htm

[clivejameson]

Re: Whirlpool ADG937/1S dishwasher drain hose retainers.

Penguin45 wrote:4812 440 18963 – hose
4819 492 68405 – clip

Not clear what’s included but those are the numbers. On the SIOS disk…….. 😀

Chris.

ok..ok…so it was late in the evening!!!! 😳

😆

[clivejameson]

Re: Whirlpool ADG722 dishwasher thingamyjig

…or get eaten by mice….

[clivejameson]

Re: Whirlpool ADG937/1S dishwasher drain hose retainers.

Again from memory (so don’t quote me) the genuine part does come with the end and clip but someone with the TDS disk might be able to help more.

[clivejameson]

Re: Drum not turning

The repair is probably very simple for an engineer….most likely the motor brushes have failed. If you feel unable to check this yourself then it’s time to call an engineer for what should be a quick and easy (cheap) repair.

Have a look in Repairs@ if you need an engineer, but if you’re going to have a go then you must of course unplug the appliance before doing anything else.

[clivejameson]

Re: Creda 48141

Thanks for the effort though….here’s a little something for the dehydration :beer:

😆

[Author]

Posts