Forum Replies Created
-
Posts
-
Re: bosch d/w bottom spray arm not turning
Sounds like diverter valve faulty – complete new heater box req.
Colin
Re: AEG 14850
Looks like this machine has an anti flood device in base – have you checked that ?
if you need info let me have your email
Coli
Re: Electrolux Water dispenser & Ice maker HELP!
I don’t know these appliances but have the service instructions – if any use to you let me have your email
Colin
Re: neff s5409x0gb/01
Check the transfer hose and the pressure chamber for blockages as this would cause that problem
Re: Zan F/F sensor
Looks Like service kit 50292181000, pm your email if you req further info on this
Colin
Re: Electrolux integrated W/Drier
I had an AEG L11842VIT – 914606106 – today – same design and think that you have to remove the front to gain access, I managed to change the outlet pump after laying machine on its front and going in thru the back panel. not a nice design
Re: zanussi zwd14581s washer dryer
Pump Assy comes as 3 parts – not as complete assy should be
Pump Body – 1325318606
Filter/Strainer – 1321368308
Pump Assy – 50286281006Have you got product number so as to check that part numbers
are correctColin
Re: One for the nomad I reckon.
I think that is correct Martin, I have only seen one of these and managed to clear without removal of front weight. I seem to remember someone on here saying that the weights tend to break when removed. Good luck on that one !
Colin
Re: Smeg DI612CA dishwasher
Fitted an inlet valve on one of these on thursday and got same fault- reduced water pressure on tap and then worked OK
E2 – Safety pressostat intervention
This alarm is generated when the safety level (PRS1) intervenes, both when there is or there is not
the full tank signal (PL0). In this situation the programme is not immediately stopped, but however
the tank is emptied and then filled. The water quantity, in this case, is decreased.
This situation can happen max 3 times consecutively in a washing programme, after these 3 times
the programme stops signalling the anomaly.
This defect can be caused by:
– defective pressostat level
– difficulty to connect the pump or faulty washing pump
– water in the safety pressostat pipe
– filling solenoid valve with high flow rate
– electronic card which does not read the “full” signal
