[Criscold]

Re: Aeg Dishwasher fan motor unit?

Yes Your Correct – comes complete Pt No.1115751115

Colin

[Criscold]

Re: Diplomat ADP8322 circulation pump.

Yes you will req hose clips whirlpool do a set
pt No. WPL481931039692

Colin

[Criscold]

Re: john lewis jlwm1201

E51 Motor power supply triac short-circuited PCB faulty; current leakage from motor or from wiring.

E52 No signal from motor tachometric generator Motor faulty; wiring faulty; PCB faulty

E53 Motor triac sensing circuit faulty PCB faulty

E54 Motor relay contacts sticking PCB faulty; current leakage from motor or from wiring

You need to enter diagnostics to find the correct error code

Colin

[Criscold]

Re: whirlpool cooker

Had one that I have been to a few times – replaced button and worked for a couple of months. Customer stated that if she turned the power off she would have trouble getting it to work again. Called back in march and removed board cleaned contacts on board – pinched connectors and has worked fine ever since

Colin

[Criscold]

Re: ZWD12270W1 Dead

If you get power across U3-1 & U3-2 on board its going to be main board req – the small board behind this one is for the dryer.
Let me have your email if you need more info

Colin

[Criscold]

Re: electrolux ewx14440w

You have mail

[Criscold]

Re: electrolux ewx14440w

Do you have or need diagnostics guide for this – I have had a lot of strange faults on these caused by low insulation on dryer heaters.

Colin

[Criscold]

Re: hotpoint wd sorted strange fault

Yes had one where heater came on without fan whilst on wash tripped overheat then machine would just sit there but could reset prog and would then work again.

Colin

[Criscold]

Re: electrolux ewx14440w

When you say aborts do you get any error codes ?

Colin

[Criscold]

Re: Bendix CWD1010 sticking

It appears to be the same as WDT1085 – 91463405100 same timer number and this one has drawings attached – might help with diagnostics ?
Colin

[Criscold]

Re: diplomat 8512 w/m

Go for the control module

Colin

[Criscold]

Re: Siemans SE25M276GB/01 leak from pump

You can get seal kit for this pump Pt No. 419027 and I also change the pump – sump seal at the same time Pt No. 171598.

Not easy job first time round 1 1/2 to 2 hours.

There is a write up somewhere on here about how to do it.

Colin

[Criscold]

Re: AEG LAVAMAT 61300W

If I remember correctly on these – the knob comes in two parts that clip together and I don’t now if it possible for the parts to become out of line

Colin

[Criscold]

Re: beko error codes

Let me have you email – can send you some info

Colin

[Criscold]

Re: Zan ZDC47100 Condenser T/Dry – not condensing?

Have you checked the seals around the drum and also the motor seal on the front fan housing. Must admit strange if you have good airflow on both Hot & Cold circuit.

Let me have your email and can send you the info on this one

Colin

[Author]

Posts