[Criscold]

Re: Zanussi DCE5655 TableTop Dishwasher Flooding

Have you checked the air chamber as this will cause over filling & leaking. Also check that the salt container lock nut hasn’t become loose.
If you need info on this machine let me have your email

Good Luck
Colin

[Criscold]

Re: electrolux EWX14440W drains then stops

Check dryer heaters – had one of these doing the same – board had been changed by another engineer and it turned out to be insulation fault on heaters

Colin

[Criscold]

Re: Zan E90 code

Communication error between PCB and display board
Configeration error – have you model or pnc

[Criscold]

Re: John Lewis (Zanussi) inline diode to t/o element

Looking at diagram & parts listing – As you say No diode shown
The only part I can see is Thermo-Regulator 16A pt No. 50252853002

Colin

[Criscold]

Re: AEG Lavamat Turbo L14710VIT

You would need to enter diagnostics to find the reason for the failure – Do you need info on this – let me have your email if req

Colin

[Criscold]

Re: Baumatic BDW13 dishwasher no heat

I have done 3 of these stats over the past couple of years. One worked for one wash and the customer replaced the machine and the other two have worked OK since repair. I think it is just a case of replace and test.

Colin

[Criscold]

Re: Zanussi zce7551 main oven faulty

You say that you are testing terminals to earth – Looking at wiring diagram the oven temperature neon is fed direct to neutrel and not through the TOC, if the toc was open circuit or the feed to it is faulty you would not get a neutrel feed to components although the temp light would come on and if you test components to earth this confirms live feed but not neutrel

[Criscold]

Re: howden HJA8640 dishwasher

This is a Beko machine – can or have you tried function tests. If you need more info on this let me have your email

Colin

[Criscold]

Re: Zanussi zce7551 main oven faulty

Or Faulty connection on terminal block

[Criscold]

Re: Rangemaster 110

Part No.P093026 rated at 220c

[Criscold]

Re: John Lewis Dryer

Sounds like airflow – check filters, I had a job a few months ago where the heater was cutting out after about 5 mins and it was caused by the filter inside the door it looked ok but it was blocked with powder – washed it under the tap and as far as I know has worked OK since

[Criscold]

Re: jlwm 1203 sticking at one minute

You have mail

[Criscold]

Re: John Lewis Dryer

Don’t think a manual reset on this one. Reasons listed are

Wiring faulty. NTC sensor incorrectly calibrated/out of position. Power relay to heater unit faulty Heater unit faulty.

Electronic board faulty

Intervention of auto-reset thermostat on the heater unit.Thermostat faulty (replace heater unit). Heater unit faulty.

Check Airflow

[Criscold]

Re: John Lewis Dryer

Error Code 60 – Heater or board Fault

[Criscold]

Re: jlwm 1203 sticking at one minute

Let me have you email & can send the info

[Author]

Posts