Forum Replies Created
-
Posts
-
Re: Tesco…
Latest on this one – still haven’t been able to contact this guy, as Ade says he has a voicemail thats not activated. Had a conversation from their customer care department in India that had no listing of him. Recently heard that there is a tie-in with them and Comet over the extended warranty/guarantee work but this has yet to be confirmed. Will keep trying to get through :rolls:
Re: Miele – not as good as everyone says.
Perhaps you would indicate where you are located in the UK and I will look into this for you. I am a ISE seller and located in Boston Lincolnshire but equally I could have arranged for the appliance to be delivered to you in wherever part of the country you reside.
Re: The most annoying call of the last 12 years
Loved that story – how often have we had one like this around our neck. 😀
Re: Changing door seal on Servis M9309 washer dryer
Front panel does not come off so you have to do it through porthole. I dont use debor but sometimes a very light application of washing up liquid in the inner groove helps. Give yourself plenty of time and do it slowly its more fiddly than difficult. Good luck
Re: Electrified
Go on then what area – as if I couldn’t guess from where but maybe less haste more speed 8) If its in my area put me down for it.
Re: Leisure HJA6100
Tim,
You could try the ‘nutsert kit’ from Farnell should do the job for you – data sheet is downloadable.
Ian.
Re: RLA80 Hotpoint is freezing. Thought it was stat, but??
Check – Brown goes to 6 on the stat and white goes to 4 on stat. If that doesn’t cure it you are likely short of gas.
Re: ISE appliances – some thoughts
And in doing so you’d be purchasing perhaps the best washing machine in Europe the new ISE10.
Re: LG WM1437BFD INFO REQ
Not to bad to do John – top off, back off, disconnect motor heater etc, front off shocks off, soap dispenser disconnect and fold back out of way, top springs and out of front she comes. Split the tub after taking bits off back and reassemble. Good to have space around you tho.
Re: RLA80 Hotpoint is freezing. Thought it was stat, but??
You need to ensure that the old thermostat is made by the same manufacturer as the new one. The numbers are not universal from one manufacturer to the next. If they are made by the same manufacturer ie Ranco or Danfoss you should be OK otherwise you have to wire it differently. So to recap same manufacturer Ranco (old) to Ranco (new) you should be alright but Ranco to Danfoss wiring change.
Re: RLA80 Hotpoint is freezing. Thought it was stat, but??
If the appliance is short of refrigerant or the compressor is failing the temperature whilst below freezing will not be cold enough to reach that required by the thermostat. Result is the appliance runs all the time and the inside back freezes up.
Re: suspected earth leakage in a whirpool american style fri
Post up the full model number and serial number and we will see what we can do for you but these units are renowned for pcb faults.
