[delta01]

Re: hotpoint wd61

thanks Martin, toc ok does the timer switch negative as i have power on all heater connections

thanks John

[delta01]

Re: zannusie zag 1120m

hi captaincaveman1 i had already checked the pump and pipes for blockages nff, it seems like if you leave it for a while it will work again but then it cuts out again

[delta01]

Re: indesit 1296w how old

thanks v much guys

[delta01]

Re: whirlepool top loader

thanks guys the utube video was exeptional, i gave the job to some one else this time but in future i will do it myself

thanks again john

[delta01]

Re: hotpoint wt960 low water level

hi Martin not sure customer had not complained of poor perfomance, however the module was replaced as i returned the previous faulty one (which had no display) so this is a different one, i had thought of trying a p/switch and will do so but not confident that will cure it thanks john

[delta01]

Re: hotpoint wt960 motor

thanks for your input iadom , will inspect more closely although the link does not look like a mod. its simply a loop of wire, even if it has been shorted would that cause the control unit to blank out ie no display, i will check motor numbers compatable as well
thanks john

[delta01]

Re: zan td485w no heat

Thanks Martin checked heater + stats + stat inside drum,all ok will investigate further

[delta01]

Re: zwd4270w wont fill

i might but i rent washers out and have a surplus o cwd’s and its a sealed tub so i don’t want to spend money on a heater in case the bearings fail

[delta01]

Re: zwd4270w wont fill

hi thanks again guys it was the dryer heater, will it work ok just as a washer with heater disconnected ?

thanks John

[delta01]

Re: zwd4270w wont fill

thanks Seamey will try that, just remembered i had a similar fault some years ago that was the dryer heater, although i would have expected it to show up on the general megohms test thanks again …John

[delta01]

Re: zwd4270w wont fill

hi heater fine whole machine reads good on megohms i checked usual things pump carbons inlet valves etc any other possibilities ?

[delta01]

Re: zwd4270w wont fill

thanks v much Martin will try that

[delta01]

Re: wt 960w module

thanks iadom i suppose that needs special equipment ?

[delta01]

Re: zan tc7103 leak etc

thanks guys, how do i access the valve ?

[delta01]

Re: hotpoint wma type module

thanks steve just trying to cut cost, have used emw b4 but you can get a new module for not a lot more from qualtex
thanks john

[Author]

Posts