Forum Replies Created
-
Posts
-
Re: Whirlpool ADG7340, won’t reset
Yep. module carries out a diagnostic at every start up.
Start up, it should take in water while pumping out to flush out the system. NTC fault would be detected during this so it would appear that all it’s done is pump out.The age of the machine is quite important too as older models have different ways of showing the codes. If you’ve got the serial number then we can determine it’s age.
Brian
Re: Whirlpool ADP9410/1WH dead.
Machine is over 10 years old. The continuous flashing light only indicates an error has occured. You have to go into the “passive test program” to show the stored failure code.
NTC fault, Water leakage and Continuous water inlet (F1, F2 and F9) will prevent the test program being run.
The procedure to run the test programs and the error codes differ from the later models.
I’ve got the procedure (clear as mud) and error codes on a pdf if you need them.
BrianRe: Whirlpool ADG7340, won’t reset
Depends on the age of it for the error code but, a faulty NTC won’t allow you to run the diagnostic program and if it’s not too old a machine, continuous flash is error code F1 – NTC fault.
Brian
Re: whirlpool s20b-a/g fridge freezer
You’ll need to see what is going on with this one.
There’s a built in diagnostic. Switch the power off to the machine, switch it back on and immediately open the freezer door and look at the right hand optic. It will flash a code to you. Don’t have the codes to hand but can remember that 2 flashes is faulty optics, 3 is faulty icemaker.Brian
Re: Diplomat d/washer ADP 8242
It’s definitely not Whirlpool. Check the known error codes for Smeg.
Brian
Re: Whirlpool auto AWM5125/3
Have you checked the carbon brushes in the motor?
If they’re ok check the motor plug and the wiring.Brian
Re: Indesit type Hotpont FDW50
Led 1 Intensive
Led 2 Normal
Led 3 Eco
Led 4 Fast
Led 5 Prewash
Led 6 Delicate3…..Overflow (water in base)-Leak from water line
BrianRe: Merry Christmas!
Wishing you all a very Merry Christmas.
My thanks to everyone for the assistance given to me this past year.
Have a wonderful holiday.Brian 😀
Re: Indesit type Hotpont FDW50
I can’t find an FDW50 but the DWF50 and FDW60 share the same fault codes. 4th led indicates a problem with the solenoid valve. (Found it in the UKWhitegoods bible 😀 )
Of course, if i’m wrong someone will be along soon to correct me.
Brian
😆
