Forum Replies Created
-
Posts
-
Re: Homark SE4400 Wiring Diagram
Hi Baz,
Got the diagram, thank you for your assistance on this one.Ta
BrianRe: Creda TCR2 Timer wiring diagram
Hi Jim,
Got the email and diagram. Thanks very much.
At least I’ll get the thing running again.Ta.
Brian 😀Re: Whirlpool AWO10761 Motor
Hiya,
9 variations of that model number. do you have the 85 number?Thanks
BrianRe: ADP8332 F2 mystery
funkyboogy wrote:look in sump area about the 12 oclock position, if their is a rubber flap valve take it of and throw it away…as grease sticks valve,
if no flap valve there should just be a hole about the size of 5p…its more then likley that grease/crap has went into hole and gundged it up.
best way to clean ..use hand help steamer..
allyHiya,
8332 is a Whirlpool, the rubber flap is on the Smeg machines. This one doesn’t have that.Brian 😀
Re: ADP8332 F2 mystery
Hiya,
Is the drain hose into a stand pipe?
If it is, check for syphoning. Might only fault if the sink is being emptied at the same time the machine is filling.Just a thought.
Brian
Re: w/pool adg642
Hiya,
Unplug the wash motor and try the machine.
You could also try it with the heater disconneted (will work till it fails on heating) and the dispenser. (Not all at the same time of course).
Finally you could try another coil on the inlet valve.If it’s still doing it with that lot checked it doesn’t leave a lot of the machine to have gone wrong.
HTH
BrianRe: kenwood dishwasher e3 fault
Hiyas,
Seems we have problems with Kenwood fault codes, any chance of posting what is known in the Known Error Codes sticky?
I’m sure some of the Kenwoods E3 is no drain but later ones are no heat.Thanks
BrianRe: w/pool adg642
Hiya,
I’m ex Whirlpool.
Sorry, flow meter is normally 6 flashes changing to 7 flashes.8 flashes can be a faulty water indicator, could be filter blocked, water foaming giving a false reading,
Syphoning can give this reading.
pot turned over and filled with water, reducing the water level
No stable spray pump workingIs the machine fitted with the Askol pump?
Has the base flooded?
When it starts does it wash ok for a little while and then start pulsing?
Check for syphoning.HTH
BrianRe: s20brsb21-a/g
Hiya,
The boards changed after week 30 2003.
If the machine is newer than this it already has the new boards.
Only the older boards cannot talk to the newer ones.
Once you change the boards on a machine it won’t need both boards in the future.
The rating plate should be marked to indicate the upgraded boards are installed.If the first six numbers of the serial is 110330 or lower, both boards. 110331 or higher, 1 board could be changed.
HTH
BrianRe: Twin Grill switch 6204036
Hiya,
Need to know the model of strix and the contacts on it.If it’s the Strix OG2004 then the terminals are the same.
Diamond H will be
Live to p1
Load 1 to 2
Neutral to 4
Load 2 to p2
S1 and S2 are for the pilot light.Hope this helps.
Brian
Re: Whirlpool AWM323 Washer
Hiya,
New switch doesn’t have the small connector on the rear. I’ve been putting new spades on the wires and slaving these into the live and neutral coming out of the switch.Hope this helps.
Brian 😀
