Forum Replies Created
-
Posts
-
I’ve tried everything including my vacuum cleaner.
This has the fridge evaporator in the roof of the fridge. I can see the end if the pipe and it looks like it has a flat ended hose on, Even blowing down doesn’t shift it.
Looks like a Job for Siemens as getting it out looks like a 2 man job.Thank for the reply.
Yes I’ve had a few with the motor mount and I’ve had success by putting some screws through the bottom of the plastic mount which is enough to lift the motor and fan slightly.
I called back today as they have now removed the radiator and checked everything I could and all seems fine.
The error code no longer comes up but after about 5 minutes the drum stops turning and a few minutes later the compressor stops but the display says its still working.
I’m going to go for the Top large pcb and will report back.
Fingers crossed.Thanks Guys
Luckily I was able to pull the plug out of the back so no neutral was connected.
Readings from the grill element wiring was almost a dead short and like I said all of the components checked out fine.
PCB will be fitted at the end of the week so I’ll update.Thanks
Thanks Dave I’ll give that a try.
I have asked her to power it off then select a program and power back on to see it it starts the correct program.Thank you so much for taking the time posting this info. This model was slightly different with lights in the cover and down the side so even more to remove but job done.
Thanks again
DavidI had one similar this week. Turned out to be the dryer fan motor having a resistance of a heating element.
