Forum Replies Created
-
Posts
-
Re: employment required – Norwich area
assume you saw this one thread down? trade-work-vacancies/white-goods-engineer-required-thetford-norfolk-t85775.html
Re: 1606 Heating element required
that part number is the Asko number (although these now have Gorenje numbers as well). Cannot help with the supply though sorry.
You could try Maytag though.
Re: liebherr ikb 3650 larder fridge temp on display 15 degre
slyp98 wrote:that would be kohms right ? i have 3.65 kohms at 6 degrees for the evap sensor
correct yes! should have pointed that out! I cut and pasted from a table that left that information out.
Are you certain you have the correct sensor? (9590142) and have you used that connector plug they supply with it correctly?
Re: Bosch oven hinge problem
would recommend changing the receiver anyway as they are cheap enough, but, if you have read the thread that Martin has pointed out, this has been a long running issue never fully resolved. Usually makes them shut tightly for a few months but then they begin to loosen up again. I think its the metal just being too soft that it wears smooth over the “heel” that the hinge roller needs to pass over to give that final push against the seal.
If its any consolation, Smeg has the same issue.Re: Bosch fill hoses
dishwasher ones you mean? They also transmit shut off noises through the customers house pipe system making a rattle in the loft. Asko Ise ones were just as bad, the metal threaded ring could easily strip the thread of the fill valves.
Re: Smeg FAB30YV – Door Seals
some you can change but if its not shown in the spares manual as a part then its a model that’s not changeable.
Re: liebherr ikb 3650 larder fridge temp on display 15 degre
as a rule, the values are:
temp/ ohms
+35 3.1
+30 3.8
+25 4.7
+20 5.9
+15 7.3
+10 9.3
+5 11.9
0 15.3
-5 19.8
-10 25.9
-15 34.1
-20 45.3
-25 60.8
-30 82.3
-35 112.8Re: Weird hoover fault?
iadom wrote:All and any suggestions gladly received, you can teach an old dog new tricks, I know that for certain with the dog we adopted from our next door neighbour. 😀
only say it because I know of an old dog caught out by tiny earth leakages upsetting electronics.Re: Weird hoover fault?
assume you have checked for heater earth faults? Disconnect it and run it anyway.
Re: bosch wae24466/gb03 error 21?
as above but don’t unplug he motor, don’t hold the spin speed button, just press it and turn the selector…. now find it works first time for me.
Re: Miele G2872 SCVI
got the correct arms for the model? should have magnets in them for the sensors.
Re: any easy ways of chnging the wm6152 lifter (2705570400)
let us know the make an maybe someone can help. assume Beko at a guess.
Re: Smeg SC45MC2 Combination Microwave Oven Issue
probably not had that issue but we do get a lot of pcb/ display issues and these have been modified accordingly and horrendously expensive to replace. Check the door switches though…..
this is a Teka made product by the way and very complex to use, many faults are users just not setting the functions correctly.
