ELDAR59

Forum Replies Created

Viewing 15 posts - 856 through 870 (of 958 total)
  • Author
    Posts
  • in reply to: Best Fridge freezer? #229110
    ELDAR59
    Participant

    Re: Best Fridge freezer?

    gilbo, you could give liebherr a call to find their nearest supplier on 0870 898 5050.

    cheers.

    in reply to: Necht Dishwasher WQP12 – 6015 #228754
    ELDAR59
    Participant

    Re: Necht Dishwasher WQP12 – 6015

    could be waste water from the sink back filling into the appliance via the waste hose.
    check the angle of the waste hose, if the machine wastes into the ‘u’ bend under the sink.
    cheers.

    in reply to: Best Fridge freezer? #229106
    ELDAR59
    Participant

    Re: Best Fridge freezer?

    hi gilbo, a miele fridge is made by liebherr.
    can’t comment on the other makes you mentioned, but liebherr is pronounced leebhair.
    imo, the liebherr is a very good product.
    have you tried looking at the frigidaire range of american fridges? they may have a narrower one.
    cheers.

    in reply to: SAMSUNG SR-S2028CVW F/F #227432
    ELDAR59
    Participant

    Re: SAMSUNG SR-S2028CVW F/F

    check the components on the defrost circuit, fridge side first.
    the problem is likely to be in there, probably the defrost heater.
    if all the components in the fridge check out ok, then try in the freezer section.

    cheers.

    in reply to: Admiral top loader #226863
    ELDAR59
    Participant

    Re: Admiral top loader

    franz, don’t be frightened of this job mate, it’s fairly easy.
    you just have to loosen the bolts that are under tension a little bit, don’t fully unscrew them, or you will know about it!
    i don’t have the tool and i’ve done quite a few of these.
    cheers.

    in reply to: maytag american f f #226676
    ELDAR59
    Participant

    Re: maytag american f f

    the most likely cause of this would be the defrost heater, followed by the compressor, but as you’ve checked these, obviously not!
    have you checked the condensor and evap fans?

    cheers.

    in reply to: Liebherr fridge freezer behaving erratically #222085
    ELDAR59
    Participant

    Re: Liebherr fridge freezer behaving erratically

    liebherr recommended engineer? i’d call them again and tell them what you’ve been told.

    F4 is a freezer evaporator sensor fault.

    a system fault wouldn’t be shown as an error code.

    cheers.

    in reply to: Samsung RS21dcns fitted cover now warm fridge #221475
    ELDAR59
    Participant

    Re: Samsung RS21dcns fitted cover now warm fridge

    simon, middle bar of fridge displayed means that the unit hasn’t defrosted within it’s time period (80mins i think).
    this fault condition points to defrost circuit.

    cheers.

    ELDAR59
    Participant

    Re: Amercian Style Fridge Required – Help on which one to ch

    as mentioned earlier in the thread, maytag or admiral.
    why not go for the genuine article, rather than american ‘style’?
    also, definately maytag or admiral over ge, i work on all of them and the maytag/admiral is a better product, imho of course 😉

    in reply to: Spares for Admiral fridge freezers #216776
    ELDAR59
    Participant

    Re: Spares or Admiral fridge freezers

    hi mate, give maytag a call on 01737 231000

    cheers.

    ELDAR59
    Participant

    Re: Fridgemaster/Frigidaire chinese manufactured refrigerati

    “suffering this epidemic”

    do you go out for free?

    in reply to: My Microwave just died, should I look inside? #199915
    ELDAR59
    Participant

    Re: My Microwave just died, should I look inside?

    hi andy, you may find the fuse could blow again some time down the line.
    it would be worth changing the normally closed micro switch in the monitor circuit, ie the door switches.
    it’s the closed one that is usually at fault, but a quick check of them all wouldn’t go amiss.

    cheers.

    in reply to: admiral top loader no fill #196254
    ELDAR59
    Participant

    Re: admiral top loader no fill

    hi mate, you checked the on board fuse?

    cheers.

    in reply to: Ranco VXO stat problem #194503
    ELDAR59
    Participant

    Re: Ranco VXO stat problem

    the vxo stat runs the appliance at a higher temperature.
    we haven’t used one for ages, they used to be used on some candy models years ago.
    you need to replace the stat with a vt9 or equivalent, which vxo clearly isn’t.
    that said, what brings you to the conclusion that the old stat didn’t have long enough defrost time?
    if the old stat had been good before, you may possibly have a system fault, i.e. gas or compressor.

    cheers.

    in reply to: WHATS THE FASTEST WAY OF DEFROSTING A FROST FREE? #189128
    ELDAR59
    Participant

    Re: WHATS THE FASTEST WAY OF DEFROSTING A FROST FREE?

    big towels and hot water, obviously taking great care of the thermal fuse!

Viewing 15 posts - 856 through 870 (of 958 total)