Forum Replies Created
-
Posts
-
Re: Qualtex v Connect
one reason some trade suppliers hide the actual part numbers as it stops shopping around so they can rip you off in secret.
Thats one big plus I give to Qualtex they dont hide part numbersDave
Re: ADP8352 Door lock problems
had a few hinges bend and it causes this problem so its likely door has been strained. door wont feel any different as it will not affect the springs etcetera but the hinge reaches its closed position before the latch engages. After that your just bending things to try and close it and as you realise it wont
Dave
Dave
Re: ADP8352 Door lock problems
bent door hinges ?
are both door springs attached ?
also take out baskets first in case its them
Dave
Re: Neff S51M63X1GB constantly cutting out
switch closes with a magnet.
so find a magnet and with your meter connected move the magnet to touch it then away again and the meter should changebit worried about the 70k ohms when open. it may be correct as they may have put a resistor across it inside. but if no resistor would expect a lot more
Dave
Re: Too many suds not enough space!
last time I saw this someone had bought hand washing powder by mistake
Dave
Re: Hotpoint LTF 11M132. Not starting no fault codes.
switch should be in the door at the top. you will have to remove the outer door first
Dave
Re: Hotpoint LTF 11M132. Not starting no fault codes.
switch is the first place I would look. to check it you would need to use a multi meter to check if the contacts are closing
Dave
Re: SIMPLE PCB REPAIR TIPS
Beko tumble dryer DCU8230
original symptoms blowing RCD
checked element found NTC to earth replaced element and still would not heat.
traced fault to resistor on board that had blown. nicked resistor off old Hotpoint board
fault curedDave
Re: Stove knobs
nothing can be broken on installation, wear and tear is possible but would be unlikely to affect all 4 knobs
Dave
Re: Dishwasher heater control
you don’t want a cheap engineer you want a good engineer to do good job at a reasonable price
try
http://www.ukwhitegoods.co.uk/search/fi … e-engineerDave
Re: Stove knobs
there is noting you can do to add a push and turn feature on your existing hob. As far as I know all hobs have a push and turn knob and some of the later ones have a thermocouple which means you have to hold the knob down for about 8 seconds otherwise the flame will go out. this also means if the gas blows out the gas supply will stop after 30 secs or so.
As for the flame height it depends on what you are seeing. is it blue or yellow flame . if yellow could be a lack of air caused by dirt.
if you are in any doubt of its safety get it checked by a gas safe engineer or change it as basic gas hobs are not that expensiveDave
Re: Kenwood Ck404 one oven dead
there may be an overheat stat but my money is on the multi bank switch behind the knob. look for burnt out contacts
Dave
