Forum Replies Created
-
Posts
-
Re: indesit IDCA8350 dryer
most indesit machines start flashing when there is a fault so you wont know till you go and see if it will reset
Dave
Re: 1 oven on New world 90dfdo range not functioning
if the clock controls the oven my first check would be to check the clock electrically. if it does control it there will be a relay that switches the oven on and off. you need to check its closing. if you post a picture of the rear of the clock will help
Dave
Re: Servis washing machine
if its gone bang scrap it they were not good machines at the best of times
if you remove the main circuit board you will probably find its blown up
Dave
Re: Wma42
very likely pcb
have you checked pcb for blown tracks or door lock triac damage?
not an unusual fault. sometimes if you hold the start button it will latch till you let go
Dave
Re: 1 oven on New world 90dfdo range not functioning
before you jump in and guess
join the 2 wires of the stat together. if oven then works your on the right track
the stat could be the cut in stat for the cooling fan
Dave
Re: Indesit Drier Sensor – Broken Wire
“no” in a word
use a crimp connector but since the wire broke by the cable tie you need to joint the wire on the sensor side of the cable tie. you need to find a bit of slack cable and pull it through.
if you dont it will break again on the crimp very quicklyDave
Re: 1 oven on New world 90dfdo range not functioning
I don’t know of any clock that defaults to manual so that strange unless the clock does not control oven
what do you mean by erratic reading ?
Dave
Re: 1 oven on New world 90dfdo range not functioning
short answer no
are you sure the clock is in manual mode?
when you first turn oven on you have to set the clock and select manual mode before the oven will work
Dave
