Forum Replies Created
-
AuthorPosts
-
electrofix
Moderatorcheck for sparking brushes
Dave
electrofix
Moderatorwell as far as i can see the error is a temp sensor open circuit
so as an engineer i would pull the stat cable off and measure it
I think is may be the stat on the compressor and since its less then £15 from miele it cant be a big problem to try it and see
Also buy parts direct from miele as other suppliers are often dearer
Dave
electrofix
Moderatorall they mean by that is they dont expect the average user to take tha case off and change parts
if you know which part it is and you can change it then miele will sell it to you
Dave
electrofix
Moderatorwell its a simple system in some ways
sensor tell the board the temp of the water. the board decides when to turn heater on
so as far as i know if the heater is ok and the heater relay ( proved by the fact it works on higher temps) it must be the board and thats going to be expensive especially if you fit it and find out your wrong
is it single or double glazed door as its almost impossible to feel lower temps through a double glazed door
Dave
electrofix
Moderatorassume temp sensor was correct one from Miele
have you tried putting the old sensor back ?
Daveelectrofix
Moderatorunfortunately miele keep tech info to themsewlves
it would need to be scanned by a technition to find the fault code to acertain the fault
all you can do as a user is to make sure all filters and the evaporator is clean of fluff so you have maximum air flow
its also unlikely any independant engineer would be able to find the fault unless they are lucky
Dave
electrofix
Moderatorchild lock ??
close match to manual
https://www.siemens-home.bsh-group.com/uk/supportdetail/product/WM14Y590GB/30#/Tabs=section-manuals/
Dave
April 4, 2024 at 9:00 pm in reply to: Hotpoint Vented Dryer TVFS83CGP(UK) – TOC Activated again after replacing #490039electrofix
Moderatorfound service manual and emailed it to you
Dave
April 4, 2024 at 8:51 pm in reply to: Hotpoint Vented Dryer TVFS83CGP(UK) – TOC Activated again after replacing #490038electrofix
Moderatorhave you had a close look at the elements to see if any of them can short or bunch up causing hot spots
Dave
electrofix
Moderatoronly ebay
if someone has one it will appear on there
Aslo you have a model of BU71N the N is the colour, change the letter and the part should be the same but different colour
also forget 4home they wont have stock unless they say it is in
https://www.hotpoint.co.uk/spare-parts?
this is the gen parts site direct
Dave
electrofix
ModeratorAs far as i can see no one we use has stock. would not expect it anyway for a seldom used part
did the glass smash ?
Dave
electrofix
Moderatorwhatever you do please dont make him a mod
Dave
electrofix
Moderatoriadom wrote:I think someone needs to invest in a dictionary. If that’s a succinct reply thank goodness he didn’t go into detail.:o https://www.ukwhitegoods.co.uk/forum…615#post890615
saw that and laughed
but for him the way he writes posts it maybe succinct lol
even reading them i get bored by the third line
Dave
electrofix
Moderatordoubt you can still getb the board due to age
there will prob be 2 board in the machineyou could ask
https://www.qualityelectronicrepairs.co.uk/
to see if they can repair
Dave
electrofix
Moderatordoes sound like thats possible
Dave
-
AuthorPosts
