[electrofix]

Re: Beko WMD 26145 T -no water can enter after sand in pipe

in a word you cant

inside the valve there are very tiny holes and although there is a filter some sand may have got through. if it does not clear itself you may have to replace the valves

Dave

[electrofix]

Re: zan zdc47200 916094547

look similar to one i went to last week only mine was the vented version

fault was machine completely dead but power was getting to the board

cure was 47 ohm resistor on the board and the power chip ( think it was LNK364GN)

Dave

[electrofix]

Re: Hotpoint fridge

check the door seal. make sure it contact all the way round when closed

Dave

[electrofix]

Re: DW686 Er3

got it wrong plugs are the other way round

but

if the heater is on motor must be

not a lot of tech info on this motor so cant help a lot

Dave

[electrofix]

Re: DW686 Er3

from the pictures i have found motor has 2 plugs

plug 1 has 3 connections
plug 2 has 2 connections

plug 1 supplies power
plug 2 is data to the main board

i do not know what voltage the motor runs at so cannot confirm what voltage you will find at the connections
there are only 2 possibilities here either A the motor is not being turned on or B the motor is faulty

Dave

[electrofix]

Re: machine isn’t spinning

can be various thing but it does sound like a blockage or a faulty pump

can be sock or colour catcher in the hose
faulty pump
drain pipe blocked ” had one the other day and it was a button in the outlet hose just where it joined the sink

Dave

[electrofix]

Re: Bosch Exxcel Stuck On Draining Process?

if the drain pump does not stop sound like the antiflood switch is on because the base has flooded

Dave

[electrofix]

Re: DW686 Er3

error 3 comes up as a heater fault

Dave

[electrofix]

Re: Tricity Bendix AW1201 W Door not Opening

from what you are saying it sounds like the door handle had snapped.

the only way of opening the door is to unplug machine, take the top off and put your hand down inside and manually push the door hook to open the door ( its not easy)

after that you need to strip the door and replace the part if that is what has broken

Dave

[electrofix]

Re: Washing machine not working

has your machine got a child lock ?

and has it been engaged by accident ?

Dave

[electrofix]

Re: bosch sms50E12gb keeps turning off

got to be a main power board fault.
not looked at these boards so don’t know what type of power supply they use but it may be fixable

Dave

[electrofix]

Re: cata selector switch model 65dme40135

there are not many manufacturers where you can say that

Dave

[electrofix]

Re: Belling 444449581 Fan Oven

two fans on in the oven to move the heat and one round the back to suck cool air into the casing to cool the controls

pull oven out and there should be a 4 inch fan at the back. this should run all the time the oven is on and carry on running for a few minutes after its turned off

Dave

[electrofix]

Re: Belling 444449581 Fan Oven

at the back of the unit is a cooling fan. chances are this fan is not working and the unit is overheating and there is a safety stat that shuts it down

Dave

[electrofix]

Re: Hotpoint 95490 drum direction

follow the link i posted to the EMW site. its a heck of a lot cheaper and he guarantees them

Dave

[Author]

Posts